Areas of application

• Optimization of small firing systems
• Monitoring of exhaust gas concentration from firing systems with all types of fuel (oil, gas and coal) as well as operational measurements with thermal incineration plants
• Room air monitoring
• Monitoring of air in fruit stores, greenhouses, fermenting cellars and warehouses
• Monitoring of process control functions
• Atmosphere monitoring during heat treatment of steel
• For use in non-potentially-explosive atmospheres

Application areas in biogas plants

• Monitoring of fermenters for generating biogas (input and pure sides)
• Monitoring of gas-driven motors (power generation)
• Monitoring of feeding of biogas into the commercial gas network

Application area of paramagnetic oxygen sensor

• Flue gas analysis
• Inerting plants
• Room air monitoring
• Medical engineering

Further applications

• Environmental protection
• Chemical plants
• Cement industry

Special versions

Separate gas paths

The ULTRAMAT 23 with 2 IR components without pump is also available with two separate gas paths. This allows the measurement of two measuring points as used e.g. for the NO_x measurement before and after the NO_x converter.
The ULTRAMAT 23 gas analyzer can be used in emission measuring systems and for process and safety monitoring.

Versions conforming to EN 14181 and EN 15267

According to EN 14181, which is standardized in the EU and required in many European countries, a QAL 1 qualification test, i.e. certification of the complete measuring system including gas paths and conditioning, is required for continuous emission monitoring systems (CEMS) . In accordance with EN 15267, this must be performed by an independent accredited authority. In Germany, for example, the test is performed by the German Technical Inspectorate (TГњV) and the test report is submitted to the Federal/State Workgroup for Emission Control (Bund/LГ¤nder-Arbeitsgemeinschaft fГјr Immissionsschutz - LAI) for examination/approval. Notification is also issued by the German Federal Environment Agency (Umweltbundesamt - UBA) in the Federal Gazette as well as by the German Technical Inspectorate (TГњV) http://www.qal1.de.
In Britain, the QAL 1 test reports are prepared by Sira Environmental of the Environmental Agency in accordance with the MCERTS scheme and submitted for approval and publication on the SIRA Environmental websites. The other European countries rely either on the German or English certification scheme.
For use in EN 14181 applications, the devices with the article numbers 7MB235X in the CEM CERT set (7MB1957) have undergone qualification testing according to German standards of EN 15267. These German Technical Inspectorate versions of the ULTRAMAT are suitable for measurement of CO, NO, SO₂ and O₂ according to 13th and 27th BlmSchV as well as TA Luft. Smallest measuring range tested and approved by the German Technical Inspectorate:

1 and 2-component analyzer

• CO: 0 to 150 mg/m³
• NO: 0 to 150 mg/m³
• SO₂: 0 to 400 mg/m³

3-component analyzer

• CO: 0 to 250 mg/m³
• NO: 0 to 250 mg/m³
• SO₂: 0 to 400 mg/m³

Also tested as additional measuring ranges in accordance with EN 15267-3:

• CO: 0 to 1 250 mg/m³
• NO: 0 to 2 000 mg/m³
• SO₂: 0 to 7 000 mg/m³

Determination of the analyzer drift according to EN 14181 (QAL 3) can be carried out manually or with a PC using the SIPROM GA maintenance and servicing software. In addition, selected manufacturers of emission evaluation computers offer the possibility to read the drift data via the analyzer's serial interface and automatically record and process it in the evaluation computer.

Version with faster response time

The connection between the two condensation traps is equipped with a stopper to lead the complete flow through the measuring cell (otherwise only 1/3 of the flow), i.e. the response time is 2/3 faster. The functions of all other components remain unchanged

Chopper compartment purging

consumption 100 ml/min (upstream pressure: approx. 3 000 hPa)