CM 4 x IO-Link ST

BU type A0

CC04

Yes

24 V DC

24 V

19.2 V; 20.5 V if IO-Link is used, as the supply voltage for IO-Link devices has to be at least 20 V at the master.

28.8 V

Yes

45 mA; without load

4

200 mA

1 W

20 m; Also applies for shielded cables

4

4

Yes

Yes

4.8 kBaud (COM1); 38.4 kBaud (COM2), 230.4 kBaud (COM3)

2 ms; dynamic, depending on user data length

32 byte; max.

32 byte; max.

32 byte; max.

32 byte; max.

2 kbyte; for each port

20 m; max.

Yes

Yes

Yes; max. 100 mA

Yes

Yes

Yes

36 µs; typically ±

Yes

Yes; 24 V DC via external terminal

Yes; For PROFINET only

Yes

250 µs

Yes

Yes

Yes; The port diagnosis is available in the IO-Link mode only.

Yes

Yes; green PWR LED

Yes; one green LED for channel status Qn (SIO mode) and port status Cn (IO-Link mode) per channel

Yes; red Fn LED

Yes; green/red DIAG LED

No

Yes

707 V DC (type test) and according to EN 50155 (routine test)

Yes; EMC for rail vehicles

Yes; EMC for signal and telecommunications systems

Yes; Railway applications - overvoltage category OV2; pollution degree PD2; rated surge voltage UNi = 0.5 kV; UNm = 24 V DC

Yes; Rail vehicles - see ambient conditions

Yes; Stationary electrical equipment - see ambient conditions

Yes; Signal and telecommunications systems - see ambient conditions; vibrations and shocks: Application point outside of tracks (1 m to 3 m away from track)

Yes; Rail vehicles - temperature class T1, horizontal mounting position, salt spray Class ST2

Yes; Rail vehicles - vibrations and shocks: Category 1 Class A/B

Yes; Rail vehicles - verification on request

-40 °C; = Tmin; Startup @ -25 °C

60 °C; = Tmax; +70 °C for 10 min (T1 acc. to EN 50155)

Tmin ... Tmax at 1080 hPa ... 795 hPa (-1000 m ... +2000 m)

100 %; RH incl. condensation/frost (no commissioning under condensation conditions)

Yes; Class 3B2 mold, fungus and dry rot spores (with the exception of fauna); Class 3B3 on request

Yes; Class 3C4 (RH < 75%) incl. salt spray according to EN 60068-2-52 (degree of severity 3). The supplied connector covers must remain on the unused interfaces during operation!

Yes; Class 3S4 incl. sand, dust. The supplied connector covers must remain on the unused interfaces during operation!

Yes; Class 5B2 mold, fungus and dry rot spores (with the exception of fauna); Class 5B3 on request

Yes; Class 5C3 (RH < 75%) including salt spray according to EN 50155 (ST2). The supplied plug covers must remain in place over the unused interfaces during operation!

Yes; Class 5S3 including sand and dust. The supplied plug covers must remain in place over the unused interfaces during operation!

15 mm

30 g

For use in railway applications, also observe the product information "SIPLUS extreme RAIL" A5E37661960A Online Support article 109736776