Monitoring
The current per output is monitored by the selectivity modules; if the set threshold of the output is
 exceeded, the output is
 switched off according to a predefined time-current characteristic curve. In addition, the supplying 24 V input voltage is constantly being monitored. As soon as this voltage threatens to fail, the path with a higher current than the set threshold is
 disconnected immediately. All other feeders continue to be supplied without interruption.

Signaling
Signaling of the faulty feeder takes place by the LEDs on the device as well as via group signaling contact or single-channel signaling. The selectivity module with single-channel signaling outputs the status of the 4 outputs cyclically by means of a serial code which can be read in by a digital PLC input.

Free function blocks for SIMATIC S7-300/400/1200/1500 for STEP 7 and TIA Portal as well as SIMOTION CPUs with SIMOTION SCOUT are available for evaluation. This enables simple integration into the S7 diagnostics and host control or HMI systems. The integration into the LOGO! logic module is also an application example.

More information, as well as the function blocks for download, can be found at:

SIMATIC S7:
http://support.automation.siemens.com/WW/view/en/61450284

SIMOTION:
http://support.automation.siemens.com/WW/view/en/82555461

LOGO!:
http://www.siemens.com/logo-application-examples

Easy visualization in the SIMATIC PCS 7 process control system is made possible by the SITOP library, which contains the function blocks and faceplates for individual channel and common signaling:http://support.industry.siemens.com/cs/ww/en/view/109476154

Connection and disconnection of the outputs
During device startup you can select between simultaneous connection of all outputs as well as sequential connection or load-dependent connection of the outputs (to reduce the peak inrush currents).

Each output can be manually connected and disconnected on the device (for example, for commissioning or service). Disconnected outputs can be connected by means of remote reset (24 V input). Prerequisite is that the outputs were not disconnected manually on the device.