SIPLUS analog outputs . Технические данные . Подробное описание, цены на оборудование Siemens. Большой выбор, низкие цены на SIPLUS analog outputs

| | | | | |

Article number	6AG1135-6HD00-7BA1	6AG1135-6HB00-2DA1
	SIPLUS ET 200SP AQ 4xU/I ST	SIPLUS ET 200SP AQ 2 X U/I HIGH SPEED
General information
Product type designation	AQ 4xU/I ST	AQ 2xU/I HS
Firmware version		V2.0
usable BaseUnits		BU type A0, A1
Color code for module-specific color identification plate		CC00
Product function
в—Џ I&M data		Yes; I&M0 to I&M3
Engineering with
в—Џ PROFIBUS as of GSD version/GSD revision		GSD Revision 5
в—Џ PROFINET as of GSD version/GSD revision		GSDML V2.3
Operating mode
в—Џ Oversampling		Yes; 2 channels per module
в—Џ MSO		No
CiR – Configuration in RUN
Reparameterization possible in RUN	Yes	Yes
Calibration possible in RUN		Yes
Supply voltage
Rated value (DC)	24 V	24 V
permissible range, lower limit (DC)	19.2 V	19.2 V
permissible range, upper limit (DC)	28.8 V	28.8 V
Reverse polarity protection		Yes
Input current
Current consumption (rated value)		45 mA; without load
Power loss
Power loss, typ.	1.5 W	0.9 W
Address area
Address space per module
в—Џ Address space per module, max.	32 byte	4 byte; + 1 byte for QI information (32 bytes in the oversampling operating mode)
Analog outputs
Number of analog outputs	4; > +60 °C max. 2x ±10 V permissible	2
Voltage output, short-circuit protection		Yes
Voltage output, short-circuit current, max.		45 mA
Cycle time (all channels), min.		125 µs
Analog output with oversampling		Yes
в—Џ Values per cycle, max.		16
в—Џ Resolution, min.		45 µs; (2 channels), 35 µs (1 channel)
Output ranges, voltage
в—Џ 0 to 10 V	Yes	Yes; 15 bit
в—Џ 1 V to 5 V	Yes	Yes; 13 bit
в—Џ -5 V to +5 V		Yes; 15 bit incl. sign
в—Џ -10 V to +10 V	Yes	Yes; 16 bit incl. sign
Output ranges, current
в—Џ 0 to 20 mA	Yes	Yes; 15 bit
в—Џ -20 mA to +20 mA	Yes	Yes; 16 bit incl. sign
в—Џ 4 mA to 20 mA	Yes	Yes; 14 bit
Connection of actuators
в—Џ for voltage output two-wire connection	Yes	Yes
в—Џ for voltage output four-wire connection	Yes	Yes
в—Џ for current output two-wire connection	Yes	Yes
Load impedance (in rated range of output)
в—Џ with voltage outputs, min.	2 kв„¦	2 kв„¦
в—Џ with voltage outputs, capacitive load, max.	1 µF	1 µF
в—Џ with current outputs, max.	500 в„¦	500 в„¦
в—Џ with current outputs, inductive load, max.	1 mH	1 mH
Destruction limits against externally applied voltages and currents
в—Џ Voltages at the outputs		30 V
Cable length
в—Џ shielded, max.		1 000 m; 200 m for voltage output
Analog value generation for the outputs
Integration and conversion time/resolution per channel
в—Џ Resolution with overrange (bit including sign), max.		16 bit
Settling time
в—Џ for resistive load		0.05 ms
в—Џ for capacitive load		0.05 ms; Max. 47 nF and 20 m cable length
в—Џ for inductive load		0.05 ms
Errors/accuracies
Output ripple (relative to output range, bandwidth 0 to 50 kHz), (+/-)		0.02 %
Linearity error (relative to output range), (+/-)	0.03 %	0.03 %
Temperature error (relative to output range), (+/-)	0.005 %/K	0.003 %/K
Crosstalk between the outputs, min.	-50 dB
Crosstalk between the outputs, max.		-50 dB
Repeat accuracy in steady state at 25 °C (relative to output range), (+/-)	0.05 %	0.03 %
Operational error limit in overall temperature range
в—Џ Voltage, relative to output range, (+/-)	0.7 %	0.4 %
в—Џ Current, relative to output range, (+/-)	0.7 %	0.4 %
Basic error limit (operational limit at 25 °C)
в—Џ Voltage, relative to output range, (+/-)	0.3 %	0.1 %
в—Џ Current, relative to output range, (+/-)	0.3 %	0.1 %
Isochronous mode
Isochronous operation (application synchronized up to terminal)		Yes
Execution and activation time (TCO), min.		70 µs
Bus cycle time (TDP), min.		125 µs
Interrupts/diagnostics/status information
Diagnostics function	Yes	Yes
Substitute values connectable		Yes
Alarms
в—Џ Diagnostic alarm		Yes
Diagnostic messages
в—Џ Monitoring the supply voltage	Yes	Yes
в—Џ Wire-break	Yes	Yes; channel-by-channel, only for output type "current"
в—Џ Short-circuit	Yes	Yes; channel-by-channel, only for output type "voltage"
в—Џ Group error	Yes	Yes
в—Џ Overflow/underflow		Yes
Diagnostics indication LED
в—Џ Monitoring of the supply voltage (PWR-LED)		Yes; green PWR LED
в—Џ Channel status display		Yes; Green LED
в—Џ for channel diagnostics		Yes; Red LED
в—Џ for module diagnostics		Yes; green/red DIAG LED
Potential separation
Potential separation channels
в—Џ between the channels		No
в—Џ between the channels and backplane bus		Yes
в—Џ between the channels and the power supply of the electronics		Yes
Permissible potential difference
between different circuits	75 V DC/60 V AC	75 V DC/60 V AC (base isolation)
Isolation
Isolation tested with	707 V DC	707 V DC (type test)
Ambient conditions
Ambient temperature during operation
в—Џ horizontal installation, min.	-40 °C; = Tmin	-40 °C; = Tmin; Startup @ -25 °C
в—Џ horizontal installation, max.	70 °C; = Tmax; > +60 °C max. 2x ±10 V permissible	60 °C; = Tmax
в—Џ vertical installation, min.	-40 °C; = Tmin
в—Џ vertical installation, max.	50 °C; = Tmax
Altitude during operation relating to sea level
в—Џ Ambient air temperature-barometric pressure-altitude	Tmin ... Tmax at 1080 hPa ... 795 hPa (-1000 m ... +2000 m) // Tmin ... (Tmax - 10K) at 795 hPa ... 658 hPa (+2000 m ... +3500 m) // Tmin ... (Tmax - 20K) at 658 hPa ... 540 hPa (+3500 m ... +5000 m)	Tmin ... Tmax at 1080 hPa ... 795 hPa (-1000 m ... +2000 m) // Tmin ... (Tmax - 10K) at 795 hPa ... 658 hPa (+2000 m ... +3500 m) // Tmin ... (Tmax - 20K) at 658 hPa ... 540 hPa (+3500 m ... +5000 m)
Relative humidity
в—Џ With condensation, tested in accordance with IEC 60068-2-38, max.	100 %; RH incl. condensation / frost (no commissioning in bedewed state), horizontal installation	100 %; RH incl. condensation / frost (no commissioning in bedewed state), horizontal installation
Use in stationary industrial systems
вЂ” to biologically active substances according to EN 60721-3-3	Yes; Class 3B2 mold, fungus and dry rot spores (with the exception of fauna); Class 3B3 on request	Yes; Class 3B2 mold, fungus and dry rot spores (with the exception of fauna); Class 3B3 on request
вЂ” to chemically active substances according to EN 60721-3-3	Yes; Class 3C4 (RH < 75%) incl. salt spray according to EN 60068-2-52 (degree of severity 3). The supplied connector covers must remain on the unused interfaces during operation!	Yes; Class 3C4 incl. salt spray according to EN 60068-2-52 (degree of severity 3). The supplied connector covers must remain on the unused interfaces during operation!
вЂ” to mechanically active substances according to EN 60721-3-3	Yes; Class 3S4 incl. sand, dust. The supplied connector covers must remain on the unused interfaces during operation!	Yes; Class 3S4 incl. sand, dust. The supplied connector covers must remain on the unused interfaces during operation!
Dimensions
Width	15 mm	15 mm
Height	73 mm	73 mm
Depth	58 mm	58 mm
Weights
Weight, approx.	31 g	31 g

skener.ru

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
Бесконтактные выключатели Конечные выключатели Оптические датчики Энкодеры

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FS - Установка умягчения

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FK - Установка обезжелезивания