|
| | | | | | | | |
 - Connection of SIMATIC S7-300/SINUMERIK 840D powerline to Industrial Ethernet
- Multi-protocol operation with TCP and UDP transport protocol
- Adjustable keep-alive function
- Two separate interfaces (integrated network separation):
- Gigabit interface with one RJ45 port with 10/100/1 000 Mbit/s, full/half-duplex with auto-sensing capability
- PROFINET interface with two RJ45 ports with 10/100 Mbit/s full/half-duplex with auto-sensing and auto-crossover functionality via integrated 2-port switch
- Communications services via both interfaces:
- Open communication (TCP/IP and UDP): Multicast with UDP, including routing between both interfaces
- PG/OP communication:
Cross-network by means of S7 routing - S7 communication (client, server, multiplexing) including routing between both interfaces
- IT communication:
HTTP communication supports access to process data via own web pages;
e-mail client function, sending of e-mails directly from user program;
FTP communication supports program-controlled FTP client communication;
access to data blocks through FTP server
- Communications services via PROFINET interfaces:
- PROFINET IO controller and IO device with real-time properties (RT and IRT)1)
- PROFINET CBA
- IP address assignment via DHCP, simple PC tool or via program block (e.g. for HMI)
- Configuration with STEP 7
- Media redundancy (MRP);
within an Ethernet network with ring topology, the CP supports the media redundancy procedure MRP (V2.2 or higher). - Access protection by means of configurable IP access list
- Module replacement without programming device;
all information is stored on the C-PLUG (also file system for IT functions) - Extensive diagnostic functions for all modules in the rack
- IT communication
- Web function
- E-mail function
- FTP
- Integration into network management systems through the support of SNMP V1 MIB-II
1) possible combinations in parallel operation:
- IO controller with IRT and IO device with RT
- IO controller with RT and IO device using IRT Note:SIPLUS extreme products are based on SIMATIC standard products. The contents listed here were taken from the respective standard products. SIPLUS extreme-specific information was added. SIPLUS S7-300 CP 343-1 Advanced | |
|---|
Article No. | 6AG1343-1GX31-4XE0 | BasedOn Article No. | 6GK7343-1GX31-0XE0 | Ambient temperature range | 0 ... +60 °C | Conformal coating | Coating of the printed circuit boards and the electronic components | Technical data | The technical data of the standard product applies, except for the ambient conditions. | Ambient conditions | Relative humidity | 100%, condensation/frost permissible. No commissioning if condensation present. | Biologically active substances, compliance with EN 60721-3-3 | Class 3B2 mold and fungal spores (excluding fauna). The supplied plug covers must remain in place over the unused interfaces during operation! | Chemically active substances, compliance with EN 60721-3-3 | Class 3C4 incl. salt spray in accordance with EN60068-2-52 (degree of severity 3). The supplied plug covers must remain in place over the unused interfaces during operation! | Mechanically active substances, compliance with EN 60721-3-3 | Class 3S4 incl. sand, dust. The supplied plug covers must remain in place over the unused interfaces during operation! | Air pressure (depending on the highest positive temperature range specified) | 1080 ... 795 hPa (-1 000 ... +2 000 m)
see ambient temperature range 795 ... 658 hPa (+2 000 ... +3 500 m)
derating 10 K 658 ... 540 hPa (+3 500 ... +5 000 m)
derating 20 K |
For technical documentation on SIPLUS, see: http://www.siemens.com/siplus-extreme
|
|
