1-phase, 3 ... 52 V DC (SITOP flexi 120 W) . Технические данные . Подробное описание, цены на оборудование Siemens. Большой выбор, низкие цены на 1-phase, 3 ... 52 V DC (SITOP flexi 120 W)

| | |

Article number		6EP1353-2BA00
Product		SITOP flexi
Power supply, type		3-52 V/2-10 A
Input
Input		1-phase AC
Supply voltage
в—Џ 1 at AC Rated value		120 V
в—Џ 2 at AC Rated value		230 V
Rated voltage value Vin rated		120 ... 230 V
в—Џ Note		Set via wire jumper
Input voltage
в—Џ 1 at AC		85 ... 132 V
в—Џ 2 at AC		170 ... 264 V
Wide-range input		No
Overvoltage resistance		2.3 Г— Vin rated, 1.3 ms
Mains buffering at Iout rated, min.		10 ms; at Pout = 120 W and Vin = 93/187 V
Rated line frequency 1		50 Hz
Rated line frequency 2		60 Hz
Rated line range		47 ... 63 Hz
Input current
в—Џ at rated input voltage 120 V		2.2 A
в—Џ at rated input voltage 230 V		0.9 A
Switch-on current limiting (+25 °C), max.		32 A
IІt, max.		0.8 AІ·s
Built-in incoming fuse		T 3,15 A/250 V (not accessible)
Protection in the mains power input (IEC 898)		Recommended miniature circuit breaker: from 6 A characteristic C
Output
Output		Controlled, isolated DC voltage
Rated voltage Vout DC		24 V
Output voltage		3-52 V DC
Total tolerance, static ±		1 %
Static mains compensation, approx.		0.1 %
Static load balancing, approx.		0.2 %
Sense line connection max. voltage control per line		0.5 V
Residual ripple peak-peak, max.		50 mV
Residual ripple peak-peak, typ.		20 mV
Spikes peak-peak, max. (bandwidth: 20 MHz)		100 mV
Spikes peak-peak, typ. (bandwidth: 20 MHz)		80 mV
Adjustment range		3 ... 52 V
Product function Output voltage adjustable		Yes
Output voltage setting		via potentiometer or analog current voltage signal 0 ... 2.5 V
Status display		Green LED for 24 V OK
Signaling		Power-Good via relay contact, current monitor signal 0 вЂ¦ 2.5 V
On/off behavior		No overshoot of Vout (soft start)
Startup delay, max.		3 s
Voltage rise, typ.		80 ms
Rated current value Iout rated		10 A
в—Џ min.		2 A
в—Џ max.		10 A
Current range		0 ... 10 A
в—Џ Note		max. 120 W
Supplied active power typical		120 W
Constant overload current
в—Џ on short-circuiting during the start-up typical		10 A
в—Џ at short-circuit during operation typical		10 A
Parallel switching for enhanced performance		Yes
Numbers of parallel switchable units for enhanced performance		2
Efficiency
Efficiency at Vout rated, Iout rated, approx.		84 %
Power loss at Vout rated, Iout rated, approx.		23 W
Protection and monitoring
Output overvoltage protection		Yes, according to EN 60950-1
Current limitation		2 ... 10 A
Current limitation		2 ... 10 A, adjustable using potentiometer or analog control voltage signal 0 ... 2.5 V
Property of the output Short-circuit proof		Yes
Short-circuit protection		Electronic current limiting (2 ... 10 A) in the range 3 ... 12 V or power limiting (120 W) in the range 12 ... 52 V
Overcurrent overload capability in normal operation		According to the adjusted current regulation 2 ... 10 A
Overload/short-circuit indicator		Red LED for current or power limiting
Safety
Primary/secondary isolation		Yes
Galvanic isolation		Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178
Protection class		Class I
Leakage current
в—Џ maximum		3.5 mA
CE mark		Yes
UL/cUL (CSA) approval		cULus-Listed (UL 508, CSA C22.2 No. 142), File E143289
Explosion protection		-
FM approval		-
CB approval		No
Marine approval		-
Degree of protection (EN 60529)		IP20
EMC
Emitted interference		EN 55022 Class B
Supply harmonics limitation		EN 61000-3-2
Noise immunity		EN 61000-6-2
Operating data
Ambient temperature
в—Џ during operation		0 ... 60 °C
вЂ” Note		with natural convection
в—Џ during transport		-40 ... +85 °C
в—Џ during storage		-40 ... +85 °C
Humidity class according to EN 60721		Climate class 3K3, no condensation
Mechanics
Connection technology		screw-type terminals
Connections
в—Џ Supply input		L1, N, PE: 1 screw terminal each for 0.5 ... 2.5 mmІ single-core/finely stranded
в—Џ Output		L+: 1 screw terminal for 0.5 ... 2.5 mmІ; M: 2 screw terminals for 0.5 ... 2.5 mmІ
в—Џ Auxiliary		Alarm signals, control inputs: 1 screw terminal each for 0.14 ... 1.5 mmІ
Width of the enclosure		75 mm
Height of the enclosure		125 mm
Depth of the enclosure		125 mm
Required spacing
в—Џ top		50 mm
в—Џ bottom		50 mm
в—Џ left		0 mm
в—Џ right		0 mm
Weight, approx.		0.9 kg
Product feature of the enclosure housing for side-by-side mounting		Yes
Installation		Snaps onto DIN rail EN 60715 35x7.5/15
MTBF at 40 °C		1 196 172 h
Other information		Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified)

skener.ru

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
Бесконтактные выключатели Конечные выключатели Оптические датчики Энкодеры

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FS - Установка умягчения

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FK - Установка обезжелезивания