1-phase, 3 ... 52 V DC (SITOP flexi 120 W) . Технические данные . Подробное описание, цены на оборудование Siemens. Большой выбор, низкие цены на 1-phase, 3 ... 52 V DC (SITOP flexi 120 W)

| | |

1-phase, 3 ... 52 V DC (SITOP flexi 120 W)

Article number		6EP1353-2BA00
Product		SITOP flexi
Power supply, type		3-52 V/2-10 A
Input
Input		1-phase AC
Supply voltage
? 1 at AC Rated value		120 V
? 2 at AC Rated value		230 V
Rated voltage value Vin rated		120 ... 230 V
? Note		Set via wire jumper
Input voltage
? 1 at AC		85 ... 132 V
? 2 at AC		170 ... 264 V
Wide-range input		No
Overvoltage resistance		2.3 ? Vin rated, 1.3 ms
Mains buffering at Iout rated, min.		10 ms; at Pout = 120 W and Vin = 93/187 V
Rated line frequency 1		50 Hz
Rated line frequency 2		60 Hz
Rated line range		47 ... 63 Hz
Input current
? at rated input voltage 120 V		2.2 A
? at rated input voltage 230 V		0.9 A
Switch-on current limiting (+25 °C), max.		32 A
I?t, max.		0.8 A?·s
Built-in incoming fuse		T 3,15 A/250 V (not accessible)
Protection in the mains power input (IEC 898)		Recommended miniature circuit breaker: from 6 A characteristic C
Output
Output		Controlled, isolated DC voltage
Rated voltage Vout DC		24 V
Output voltage		3-52 V DC
Total tolerance, static ±		1 %
Static mains compensation, approx.		0.1 %
Static load balancing, approx.		0.2 %
Sense line connection max. voltage control per line		0.5 V
Residual ripple peak-peak, max.		50 mV
Residual ripple peak-peak, typ.		20 mV
Spikes peak-peak, max. (bandwidth: 20 MHz)		100 mV
Spikes peak-peak, typ. (bandwidth: 20 MHz)		80 mV
Adjustment range		3 ... 52 V
Product function Output voltage adjustable		Yes
Output voltage setting		via potentiometer or analog current voltage signal 0 ... 2.5 V
Status display		Green LED for 24 V OK
Signaling		Power-Good via relay contact, current monitor signal 0 … 2.5 V
On/off behavior		No overshoot of Vout (soft start)
Startup delay, max.		3 s
Voltage rise, typ.		80 ms
Rated current value Iout rated		10 A
? min.		2 A
? max.		10 A
Current range		0 ... 10 A
? Note		max. 120 W
Supplied active power typical		120 W
Constant overload current
? on short-circuiting during the start-up typical		10 A
? at short-circuit during operation typical		10 A
Parallel switching for enhanced performance		Yes
Numbers of parallel switchable units for enhanced performance		2
Efficiency
Efficiency at Vout rated, Iout rated, approx.		84 %
Power loss at Vout rated, Iout rated, approx.		23 W
Protection and monitoring
Output overvoltage protection		Yes, according to EN 60950-1
Current limitation		2 ... 10 A
Current limitation		2 ... 10 A, adjustable using potentiometer or analog control voltage signal 0 ... 2.5 V
Property of the output Short-circuit proof		Yes
Short-circuit protection		Electronic current limiting (2 ... 10 A) in the range 3 ... 12 V or power limiting (120 W) in the range 12 ... 52 V
Overcurrent overload capability in normal operation		According to the adjusted current regulation 2 ... 10 A
Overload/short-circuit indicator		Red LED for current or power limiting
Safety
Primary/secondary isolation		Yes
Galvanic isolation		Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178
Protection class		Class I
Leakage current
? maximum		3.5 mA
CE mark		Yes
UL/cUL (CSA) approval		cULus-Listed (UL 508, CSA C22.2 No. 142), File E143289
Explosion protection		-
FM approval		-
CB approval		No
Marine approval		-
Degree of protection (EN 60529)		IP20
EMC
Emitted interference		EN 55022 Class B
Supply harmonics limitation		EN 61000-3-2
Noise immunity		EN 61000-6-2
Operating data
Ambient temperature
? during operation		0 ... 60 °C
— Note		with natural convection
? during transport		-40 ... +85 °C
? during storage		-40 ... +85 °C
Humidity class according to EN 60721		Climate class 3K3, no condensation
Mechanics
Connection technology		screw-type terminals
Connections
? Supply input		L1, N, PE: 1 screw terminal each for 0.5 ... 2.5 mm? single-core/finely stranded
? Output		L+: 1 screw terminal for 0.5 ... 2.5 mm?; M: 2 screw terminals for 0.5 ... 2.5 mm?
? Auxiliary		Alarm signals, control inputs: 1 screw terminal each for 0.14 ... 1.5 mm?
Width of the enclosure		75 mm
Height of the enclosure		125 mm
Depth of the enclosure		125 mm
Required spacing
? top		50 mm
? bottom		50 mm
? left		0 mm
? right		0 mm
Weight, approx.		0.9 kg
Product feature of the enclosure housing for side-by-side mounting		Yes
Installation		Snaps onto DIN rail EN 60715 35x7.5/15
MTBF at 40 °C		1 196 172 h
Other information		Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified)

skener.ru

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
Бесконтактные выключатели Конечные выключатели Оптические датчики Энкодеры

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FS - Установка умягчения

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FK - Установка обезжелезивания