6ES7193-6LA10-0AG0

Цена на сайте указана розничная в ЕВРО без учета НДС.
Для уточнения цены и размера предоставляемой скидки - звоните или присылайте заявки

2-channel pulse output module for SIPLUS ET 200SP

• Operating modes:
  • Single pulse with defined length
  • Pulse chain with defined number of pulses
  • Pulse width modulation (with flexible ON period, optional current control and dither function)
  • PWM signal for controlling a DC motor
  • On and OFF delay; rising and falling edge can be delayed separately to the microsecond
  • Frequency output with defined output frequency
• Hardware:
  • 2 24V channels, 2A output current can be switched in parallel to boost performance to 4A of output current
  • Switching frequencies to 10 kHz; at reduced output current to 0.1 A up to 100 kHz
  • Push/pull output driver for especially steep edges at the outputs
  • Polarity change in DC motor operation for direction reversal
  • 1 high-speed 24В V digital input per channel with parameterizable input delay from 4В Вµs
• Channel functions:
  • HW enable;
    Start of signal output with the onboard digital input
  • Parameterizable ON delay;
    for precise deceleration between the HW enable and the start of output
  • Current measurement in the operating modes pulse-width modulation and pulse chain;
    enables control of the output current mean value over a period. Temperature influences can thus be balanced to the resistance of the actuator.
  • Cyclic control of the respective main setpoint from the PLC in every operating mode;
    other values can be modified flexibly from the user program.
• Supported system functions:
  • Isochronous mode;
    enables precision-timed connection of the setpoint output to a higher-level controller
  • Firmware update
  • Identification data I&M

Note

SIPLUS extreme products are based on SIMATIC standard products. The contents listed here were taken from the respective standard products. SIPLUSВ extreme specific information was added.