Time-based IO module SIPLUS TM timer DIDQ 10x24 V . Технические данные . Подробное описание, цены на оборудование Siemens. Большой выбор, низкие цены на Time-based IO module SIPLUS TM timer DIDQ 10x24 V

| | | | | | |

Article number		6AG1138-6CG00-2BA0
		SIPLUS ET 200SP TM TIMER DIDQ 10x24V
General information
Product type designation		TM Timer DIDQ 10x24V
usable BaseUnits		BU type A0
Product function
в—Џ I&M data		Yes; I&M 0
Supply voltage
Load voltage L+
в—Џ Rated value (DC)		24 V
в—Џ permissible range, lower limit (DC)		19.2 V
в—Џ permissible range, upper limit (DC)		28.8 V
в—Џ Reverse polarity protection		Yes; against destruction
Input current
Current consumption, max.		50 mA; without load
Encoder supply
Number of outputs		1
24 V encoder supply
в—Џ 24 V		Yes; L+ (-0.8 V)
в—Џ Short-circuit protection		Yes
в—Џ Output current, max.		500 mA; Observe derating
Power loss
Power loss, typ.		1.5 W
Address area
Occupied address area
в—Џ Inputs		26 byte
в—Џ Outputs		32 byte
Digital inputs
Number of digital inputs		4
Digital inputs, parameterizable		Yes
Input characteristic curve in accordance with IEC 61131, type 3		Yes
Digital input functions, parameterizable
в—Џ Digital input with time stamp		Yes
вЂ” Number, max.		4
в—Џ Counter		Yes
вЂ” Number, max.		3
в—Џ Counter for incremental encoder		Yes
вЂ” Number, max.		1
в—Џ Digital input with oversampling		Yes
вЂ” Number, max.		4
в—Џ HW enable for digital input		Yes
вЂ” Number, max.		1
в—Џ HW enable for digital output		Yes
вЂ” Number, max.		3
Input voltage
в—Џ Type of input voltage		DC
в—Џ Rated value (DC)		24 V
в—Џ for signal "0"		-30 to +5V
в—Џ for signal "1"		+11 to +30V
в—Џ permissible voltage at input, min.		-30 V
в—Џ permissible voltage at input, max.		30 V
Input current
в—Џ for signal "1", typ.		2.5 mA
Input delay (for rated value of input voltage)
в—Џ Minimum pulse width for program reactions		3 µs for parameterization "none"
for standard inputs
вЂ” parameterizable		Yes; none / 0.05 / 0.1 / 0.4 / 0.8 ms
вЂ” at "0" to "1", min.		4 µs
вЂ” at "1" to "0", min.		4 µs
Cable length
в—Џ shielded, max.		1 000 m; Depending on sensor, cable quality and rate of change
в—Џ unshielded, max.		600 m; Depending on sensor, cable quality and rate of change
Digital outputs
Type of digital output		Transistor
Number of digital outputs		6
Current-sinking		Yes; With High Speed output
Current-sourcing		Yes
Digital outputs, parameterizable		Yes
Short-circuit protection		Yes; electronic/thermal
в—Џ Response threshold, typ.		1.7 A with Standard output, 0.5 A with High Speed output
Limitation of inductive shutdown voltage to		-0.8 V
Digital output functions, parameterizable
в—Џ Digital output with time stamp		Yes
вЂ” Number, max.		6
в—Џ PWM output		Yes
вЂ” Number, max.		6
в—Џ Digital output with oversampling		Yes
вЂ” Number, max.		6
Switching capacity of the outputs
в—Џ with resistive load, max.		0.5 A; 0.1 A with High Speed output
в—Џ on lamp load, max.		5 W; 1 W with High Speed output
Load resistance range
в—Џ lower limit		48 в„¦; 240 ohm with High Speed output
в—Џ upper limit		12 kв„¦
Output voltage
в—Џ Type of output voltage		DC
в—Џ for signal "0", max.		1 V; With High Speed output
в—Џ for signal "1", min.		23.2 V; L+ (-0.8 V)
Output current
в—Џ for signal "1" rated value		0.5 A; 0.1 A with High Speed output, observe derating
в—Џ for signal "1" permissible range, max.		0.6 A; 0.12 A with High Speed output, observe derating
в—Џ for signal "1" minimum load current		2 mA
в—Џ for signal "0" residual current, max.		0.5 mA
Output delay with resistive load
в—Џ "0" to "1", max.		1 µs; With High Speed output, 5 µs with Standard output
в—Џ "1" to "0", max.		1 µs; With High Speed output, 6 µs with Standard output
Switching frequency
в—Џ with resistive load, max.		10 kHz
в—Џ on lamp load, max.		10 Hz
Total current of the outputs
в—Џ Current per module, max.		3.5 A; Observe derating
Cable length
в—Џ shielded, max.		1 000 m; Depending on load and cable quality
в—Џ unshielded, max.		600 m; Depending on load and cable quality
Encoder
Connectable encoders
в—Џ Incremental encoder (asymmetrical)		Yes
в—Џ 24 V initiator		Yes
в—Џ 2-wire sensor		Yes
вЂ” permissible quiescent current (2-wire sensor), max.		1.5 mA
Encoder signals, incremental encoder (asymmetrical)
в—Џ Input voltage		24 V
в—Џ Input frequency, max.		50 kHz
в—Џ Counting frequency, max.		200 kHz; with quadruple evaluation
в—Џ Cable length, shielded, max.		600 m; Depending on input frequency, encoder and cable quality; max. 200 m at 50 kHz
в—Џ Incremental encoder with A/B tracks, 90° phase offset		Yes
в—Џ Pulse encoder		Yes
Encoder signal 24 V
вЂ” permissible voltage at input, min.		-30 V
вЂ” permissible voltage at input, max.		30 V
Interface types
в—Џ Input characteristic curve in accordance with IEC 61131, type 3		Yes
Isochronous mode
Isochronous operation (application synchronized up to terminal)		Yes
Bus cycle time (TDP), min.		375 µs
Jitter, max.		1 µs
Interrupts/diagnostics/status information
Diagnostics function		Yes
Substitute values connectable		Yes
Alarms
в—Џ Diagnostic alarm		Yes
Diagnostic messages
в—Џ Monitoring the supply voltage		Yes
в—Џ Short-circuit		Yes
Diagnostics indication LED
в—Џ Monitoring of the supply voltage (PWR-LED)		Yes; green PWR LED
в—Џ Channel status display		Yes
в—Џ for module diagnostics		Yes; green/red DIAG LED
Integrated Functions
Number of counters		3
Counting frequency (counter) max.		200 kHz; with quadruple evaluation
Counting functions
в—Џ Continuous counting		Yes
Potential separation
Potential separation channels
в—Џ between the channels and backplane bus		Yes
Ambient conditions
Ambient temperature during operation
в—Џ horizontal installation, min.		-40 °C
в—Џ horizontal installation, max.		60 °C; = Tmax; see Derating BasedOn (e.g. manual)
в—Џ vertical installation, min.		0 °C
в—Џ vertical installation, max.		50 °C; = Tmax; see Derating BasedOn (e.g. manual)
Altitude during operation relating to sea level
в—Џ Ambient air temperature-barometric pressure-altitude		Tmin ... Tmax at 1080 hPa ... 795 hPa (-1000 m ... +2000 m) // Tmin ... (Tmax - 10K) at 795 hPa ... 658 hPa (+2000 m ... +3500 m) // Tmin ... (Tmax - 20K) at 658 hPa ... 540 hPa (+3500 m ... +5000 m)
Relative humidity
в—Џ With condensation, tested in accordance with IEC 60068-2-38, max.		100 %; RH incl. condensation / frost (no commissioning in bedewed state), horizontal installation
Use in stationary industrial systems
вЂ” to biologically active substances according to EN 60721-3-3		Yes; Class 3B2 mold, fungus and dry rot spores (with the exception of fauna); Class 3B3 on request
вЂ” to chemically active substances according to EN 60721-3-3		Yes; Class 3C4 (RH < 75%) incl. salt spray according to EN 60068-2-52 (degree of severity 3). The supplied connector covers must remain on the unused interfaces during operation!
вЂ” to mechanically active substances according to EN 60721-3-3		Yes; Class 3S4 incl. sand, dust. The supplied connector covers must remain on the unused interfaces during operation!
Decentralized operation
to SIMATIC S7-1500		Yes
Dimensions
Width		15 mm
Height		73 mm
Depth		58 mm
Weights
Weight, approx.		45 g

skener.ru

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
Бесконтактные выключатели Конечные выключатели Оптические датчики Энкодеры

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FS - Установка умягчения

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FK - Установка обезжелезивания