Basic device . Технические данные . Подробное описание, цены на оборудование Siemens. Большой выбор, низкие цены на Basic device

| | |

Article number		6ES7655-5PX11-0XX0
		SIMATIC CFU PA
General information
Product type designation		Compact Field Unit
HW functional status		E01
Firmware version		V1.0
в—Џ FW update possible		Yes
Vendor identification (VendorID)		002AH
Device identifier (DeviceID)		060DH
Number of channels		16
Product function
в—Џ I&M data		Yes; I&M0 to I&M4
в—Џ The user can configure digital channels as input/output as required		Yes
в—Џ Digital channels can be parameterized		Yes
Engineering with
в—Џ STEP 7 TIA Portal configurable/integrated as of version		- / -
в—Џ STEP 7 configurable/integrated as of version		From STEP 7 V5.6 HF1 and higher
в—Џ PCS 7 configurable/integrated as of version		V9.0
в—Џ PROFIBUS as of GSD version/GSD revision		- / -
Installation type/mounting
Mounting		on 35 mm DIN rail, 2 spacing units wide
Mounting position		Horizontal, vertical
Supply voltage
Type of supply voltage		24 V DC
Rated value (DC)		24 V
permissible range, lower limit (DC)		19.2 V
permissible range, upper limit (DC)		28.8 V
Reverse polarity protection		Yes
Short-circuit protection		Yes
Redundant power supply		Yes
Mains buffering
в—Џ Mains/voltage failure stored energy time		5 ms; Bridging for field devices and communication
Input current
Current consumption (rated value)		2.5 A
Current consumption, max.		2.55 A
Inrush current, max.		8 A
IІt		0.3 AІ·s
Encoder supply
Number of outputs		8
Output voltage encoder supply, min.		18.2 V
Short-circuit protection		Yes; Electronic
Output current
в—Џ up to 60 °C, max.		2 A
в—Џ up to 70 °C, max.		1 A
Power loss
Power loss, typ.		8.2 W; Depending on the type of BusAdapter used (typ. RJ45)
Address space per station
в—Џ Address space per station, max.		1 440 byte; Dependent on configuration
Digital inputs
Number of digital inputs		8
Source/sink input		Yes; P-reading
Input characteristic curve in accordance with IEC 61131, type 1		Yes
Input characteristic curve in accordance with IEC 61131, type 2		No
Input characteristic curve in accordance with IEC 61131, type 3		Yes
Pulse extension		No
Number of simultaneously controllable inputs
horizontal installation
вЂ” up to 60 °C, max.		8; Total current must be observed, see DQ
вЂ” up to 70 °C, max.		8; Total current must be observed, see DQ
vertical installation
вЂ” up to 60 °C, max.		8; Total current must be observed, see DQ
Input voltage
в—Џ Rated value (DC)		24 V
в—Џ for signal "0"		-30 to +5V
в—Џ for signal "1"		+11 to +30V
Input current
в—Џ for signal "1", typ.		2.5 mA; Typical
Input delay (for rated value of input voltage)
for standard inputs
вЂ” parameterizable		No
вЂ” at "0" to "1", max.		3.2 ms
вЂ” at "1" to "0", max.		3.2 ms
Cable length
в—Џ shielded, max.		1 000 m
в—Џ unshielded, max.		600 m
Digital outputs
Type of digital output		Transistor
Number of digital outputs		8
Current-sinking		No
Current-sourcing		Yes
Short-circuit protection		Yes
в—Џ Response threshold, typ.		0.7 to 1.3 A
Limitation of inductive shutdown voltage to		Typ. L+ (-50 V)
Controlling a digital input		Yes
Switching capacity of the outputs
в—Џ on lamp load, max.		5 W
Load resistance range
в—Џ lower limit		48 в„¦
в—Џ upper limit		12 kв„¦
Output voltage
в—Џ Type of output voltage		DC
в—Џ for signal "1", min.		Ue minus 1 V
Output current
в—Џ for signal "1" rated value		0.5 A
в—Џ for signal "0" residual current, max.		0.1 mA
Output delay with resistive load
в—Џ "0" to "1", max.		50 µs
в—Џ "1" to "0", max.		100 µs
Parallel switching of two outputs
в—Џ for uprating		No
в—Џ for redundant control of a load		No
Switching frequency
в—Џ with resistive load, max.		100 Hz
в—Џ with inductive load, max.		2 Hz
в—Џ on lamp load, max.		10 Hz
Total current of the outputs
в—Џ Current per channel, max.		0.5 A
horizontal installation
вЂ” up to 70 °C, max.		1 A
vertical installation
вЂ” up to 60 °C, max.		2 A
Cable length
в—Џ shielded, max.		1 000 m
в—Џ unshielded, max.		600 m
Encoder
Connectable encoders
в—Џ 2-wire sensor		Yes
вЂ” permissible quiescent current (2-wire sensor), max.		1.5 mA
Interfaces
Number of PROFINET interfaces		1
Number of PROFIBUS interfaces		0
PROFIBUS PA
в—Џ Transmission rate, max.		31.25 kbit/s
в—Џ Number of connectable PA field devices		8; Electrically isolated from other interfaces, isolation tested at 2 500 V DC
в—Џ Current output to PA field devices, max.		320 mA
в—Џ permissible current per spur line		40 mA
в—Џ Automatic addressing		Yes
в—Џ System-supported integration of field devices via PA profiles		Yes
в—Џ Extended fieldbus diagnostics		Yes
1. Interface
Interface type		PROFINET
Isolated		Yes
Interface types
в—Џ Number of ports		2
в—Џ integrated switch		Yes
в—Џ BusAdapter (PROFINET)		Yes
Functionality
в—Џ PROFINET IO Device		Yes
в—Џ PROFIBUS DP slave		No
Interface types
RJ 45 (Ethernet)
в—Џ 100 Mbps		Yes
в—Џ Autonegotiation		Yes
в—Џ Autocrossing		Yes
Protocols
Supports protocol for PROFINET IO		Yes
PROFINET IO Device
Services
вЂ” MRP		Yes
вЂ” PROFINET system redundancy		Yes; Type S2
Open IE communication
в—Џ LLDP		Yes
Isochronous mode
Isochronous operation (application synchronized up to terminal)		No
Interrupts/diagnostics/status information
Status indicator		Yes
Alarms		Yes
Diagnostic functions		Yes
Diagnostic messages
в—Џ Monitoring of encoder power supply		Yes
в—Џ Wire-break		Yes
в—Џ Short-circuit		Yes
Diagnostics indication LED
в—Џ RUN LED		Yes; Green LED
в—Џ ERROR LED		Yes; Red LED
в—Џ MAINT LED		Yes; yellow LED
в—Џ Monitoring of the supply voltage (PWR-LED)		Yes
в—Џ Digital input status indicator		Yes
в—Џ Digital output status indicator		Yes
в—Џ Spur line status/fault		Yes
Potential separation
between the channels and PROFINET		Yes
Potential separation digital inputs
в—Џ between the channels		No
в—Џ between the channels and the power supply of the electronics		No
Potential separation digital outputs
в—Џ between the channels		No
в—Џ between the channels and the power supply of the electronics		No
Isolation
Isolation tested with		1 500 V AC between PROFINET and electronics
Degree and class of protection
Degree of protection acc. to EN 60529		IP20
Ambient conditions
Ambient temperature during operation
в—Џ min.		-40 °C
в—Џ max.		70 °C
в—Џ horizontal installation, min.		-40 °C
в—Џ horizontal installation, max.		70 °C; Observe derating
в—Џ vertical installation, min.		-40 °C
в—Џ vertical installation, max.		60 °C; Observe derating
Ambient temperature during storage/transportation
в—Џ min.		-40 °C
в—Џ max.		85 °C
Relative humidity
в—Џ Operation, max.		95 %
Connection method
Design of electrical connection		Connection plug
Spur line
в—Џ Number of spur lines		8
в—Џ Type of cable		Type A
в—Џ Cable diameter, min.		6 mm
в—Џ Cable diameter, max.		12 mm
в—Џ Conductor cross-section, min.		0.2 mmІ
в—Џ Conductor cross-section, max.		2.5 mmІ
в—Џ Cable length, max.		120 m
в—Џ total current output to field devices, max.		320 mA
в—Џ Number of connectable field devices		8
в—Џ Current limitation per field device, max.		40 mA
в—Џ No-load voltage, max.		15.3 V
в—Џ short-circuit proof		Yes
в—Џ Short-circuit current (test current); max.		8 mA
в—Џ intrinsically safe according to FISCO model		Yes
в—Џ Debounce logic		Yes
Dimensions
Width		300 mm; 329 mm
Height		115 mm; 123 mm
Depth		40 mm; 74 mm
Weights
Weight, approx.		580 g