The SINAMICS G110M distributed inverters are modular frequency inverters for standard drives. Each SINAMICS G110M comprises two operative units – a Power Module and a Control Unit.

SINAMICS G110M CU240M PN Control Unit plug-in and PM240M Power Module FSA 1.5 kW

Power Modules

SINAMICS G110M PM240M Power Module FSA 1.5 kW

The following PM240M Power Modules are available for the SINAMICS G110M distributed inverters:

Control Units

SINAMICS G110M CU240M PN Control Unit cable gland

A Control Unit performs closed-loop control functions for the inverter. In addition to the closed-loop control, it has additional functions that can be adapted to the particular application through parameterization.

The following Control Units are available for SINAMICS G110M distributed inverters:

CU240M Control Units

Several Control Units are available in different versions:

Supplementary system components

Intelligent Operator Panel IOP‑2 Handheld

The IOP‑2 Handheld supports both newcomers and drive experts. Thanks to the large plain text display, menu-based operation and the application wizards, it is easy to commission, diagnose and locally control standard drives.

Memory card

The parameter settings for the inverter and the firmware can be stored on the SINAMICS SD memory card. When service is required, e.g. after the inverter has been replaced and the data have been downloaded from the memory card, the system is immediately ready for use again.

PC inverter connection kit (mini USB interface cable) for communication with a PC

For controlling and commissioning an inverter directly from a PC if the appropriate software (STARTER commissioning tool V4.3 and higher or SINAMICS Startdrive V13 and higher) has been installed.

Internal braking resistors

Excess energy in the DC link is dissipated in the internal braking resistor.

24 V DC power supply

A 24 V DC power supply is also available for SINAMICS G110M. This is mounted directly on the inverter and supplies the device with 24 V DC, so there is no need to connect an external 24 V DC power supply.

Wall mounting kit

If a SINAMICS G110M distributed inverter should not or cannot be mounted on the motor, a wall mounting kit is available. With the wall mounting kit SINAMICS G110M can be mounted close to the motor – according to the conditions of the plant.

Repair switch

For SINAMICS G110M a repair switch is available. This is mounted directly on the inverter and separates SINAMICS G110M on the input side from the 400 V line supply.

Connecting cables for the Control Units

Flexible plug-in cables to transfer data between the Industrial Ethernet stations or PROFIBUS stations, as well as to supply power to the Control Unit.

Connecting cables for the Power Modules

Connector sets and pre-assembled cables for the line supply can be ordered as accessories.

Installation kits

Different installation kits can be ordered as accessories for the Control Units with plug-in connections and Control Units with cable gland connections.

These kits include covers or cable glands for protecting or connecting the 400 V 3 AC supply, the 24 V DC supply and the mechanical motor brake.

Spare Parts Kit

A Spare Parts Kit is available which comprises small parts such as seals, caps and screws.