SIPLUS CMS1200 SM 1281 shield clamp set

CMS1200 accessories

SIPLUS CMS1200 SM 1281 shield clamp set, 6AT8007‑1AA20-0AA0

An additional shield clamp set must be ordered for the EMC-compliant connection of cables to the SIPLUS CMS1200 SM 1281 Condition Monitoring.

The shield clamp set comprises two shield clamps and five terminal clamps. One shield clamp is screwed on above and one below the module. The sensor cable shields are connected to the shield clamps by means of the terminal clamps.

VIB-SENSOR S01 vibration sensor

VIB-SENSOR S01 vibration sensor

VIB‑SENSOR S01 6AT8002‑4AB00 vibration sensor

The VIB-SENSOR S01 vibration sensor with IEPE (integrated electronics piezo-electric) interface can be directly connected to the CMS1200 SM1281 Condition Monitoring Module.

The sensor detects vibration accelerations in the frequency range from 0.5 Hz to 15 kHz with a resolution of 100 mV/g.

A threaded screw with an M8 thread for mounting to the measuring point is included in the scope of supply. The connecting cable is connected to the vibration sensor via the MIL connector.

SIPLUS CABLE‑MIL connecting cables

SIPLUS CABLE‑MIL connecting cables

SIPLUS CABLE‑MIL connecting cables 6AT8002‑4AC03, 6AT8002‑4AC10

The VIB‑SENSOR S01 vibration sensor is connected to the SIPLUS CMS1200 SM1281 Condition Monitoring Module by means of the SIPLUS CABLE‑MIL connecting cable.

This high-quality industrial cable is made of black polyurethane and is pre-assembled on one end with a MIL connector (MIL‑C5015). The open cable end of the shielded two-wire cable is connected directly to the screw terminals of the basic unit.

The connecting cable is available in lengths of 3 m and 10 m.