The CPU 315T-3 PN/DP has the same functionality as the high-performance CPU 315 as well as additional integrated functions for technology/motion control. Integrated, fast I/O for technical functions such as cam switching or home position detection round off the module.

The CPU 315T-3 PN/DP features:

• Microprocessor;
  the processor can handle execution times of approx. 0.05 µs per binary instruction and 0.45 µs per floating-point instruction. The CPU 315T-3 PN/DP reaches very high processing speeds, particularly where word or double-word commands and 32 bit fixed-point commands are concerned.
• 384 KB work memory (corresponds to approx. 128 K instructions);
  the extensive work memory for program components relevant to execution offers sufficient space for user programs. SIMATIC Micro Memory Cards (8 MB) as load memory for the program also allow the project to be stored in the CPU (complete with symbols and comments) and can be used for data archiving and recipe management.
• Integrated inputs and outputs
  4 digital inputs and 8 digital outputs, can be used for technical functions such as home position detection (BERO) or rapid cam switching signals.
  The digital inputs can also be used (with some restrictions) in the STEP 7 user program.
• Flexible expansion;
  up to 8 modules (single-tier configuration)
• Combined MPI/DP interface;
  The first MPI/DP integrated interface can establish as many as 32 connections simultaneously to S7-300/400 or connections to PG, PC, OP. Among these connections, one is always reserved for programming devices and another for OPs. A simple network with up to 32 CPUs can be configured with the MPI and "global data communication".
  This interface can be reconfigured from an MPI to a PROFIBUS DP interface. The DP interface can be used as a DP master or as a DP slave.
• PROFIBUS DP (DRIVE) interface:
  The PROFIBUS DP (DRIVE) interface supports isochronous mode and therefore provides an essential requirement to control high-speed and time-critical operations, such as are found in distributed axes in synchronized applications. The interface can only be used as a DP master. It serves to connect drive components. DP-V0 slaves can also be operated on the DP (DRIVE) line on a limited basis in addition to drive systems. The connectable drives are specified in the technical specifications.
  A list of the drives that can be operated on the DP-Drive can be found at:
  http://support.automation.siemens.com
  
• PROFINET
  The third integral interface of the CPU 315T-3 PN/DP is a PROFINET interface with 2-port switch, based on Ethernet TCP/IP. It supports the following protocols:
  • S7 communication for data communication between SIMATIC controllers
  • PG/OP communication for programming, commissioning and diagnostics through STEP 7
  • PG/OP communication for interfacing to HMI and SCADA
  • Open TCP/IP, UDP and ISO-on-TCP (RFC1006) communication over PROFINET
  • SIMATIC NET OPC-Server for communication with other controllers and I/O devices with own CPU