Special fail-safe modules . Технические данные . Подробное описание, цены на оборудование Siemens. Большой выбор, низкие цены на Special fail-safe modules

| | | | | |

Article number		6ES7136-6PA00-0BC0
		ET 200SP, POWERMOD. F-PM-E PPM, 24V DC
General information
Product type designation		F-PM-E 24 V DC/8 A PPM ST
usable BaseUnits		BU type C0
Color code for module-specific color identification plate		CC52
Product function
в—Џ I&M data		Yes; I&M0 to I&M3
Engineering with
в—Џ STEP 7 TIA Portal configurable/integrated as of version		V12
в—Џ STEP 7 configurable/integrated as of version		V5.5 SP3 / -
в—Џ PROFIBUS as of GSD version/GSD revision		V2.3
в—Џ PROFINET as of GSD version/GSD revision		V2.31
Supply voltage
Rated value (DC)		24 V
permissible range, lower limit (DC)		20.4 V
permissible range, upper limit (DC)		28.8 V
Reverse polarity protection		Yes
Input current
Current consumption (rated value)		75 mA; without load
Current consumption, max.		21 mA; From the backplane bus
Output voltage
Rated value (DC)		24 V
Encoder supply
Number of outputs		2
Short-circuit protection		Yes; Electronic (response threshold 0.7 A to 2.1 A)
Output current
в—Џ up to 60 °C, max.		0.3 A
24 V encoder supply
в—Џ 24 V		Yes; min. L+ (-1.5 V)
в—Џ Short-circuit protection		Yes
в—Џ Output current, max.		600 mA; Total current of all encoders
Power
Power available from the backplane bus		70 mW
Power loss
Power loss, typ.		5 W
Address area
Address space per module
в—Џ Inputs		7 byte
в—Џ Outputs		5 byte
Hardware configuration
Automatic encoding		Yes
в—Џ Electronic coding element type F		Yes
Digital inputs
Number of digital inputs		2
Source/sink input		Yes; P-reading
Input characteristic curve in accordance with IEC 61131, type 1		Yes
Input voltage
в—Џ Type of input voltage		DC
в—Џ Rated value (DC)		24 V
в—Џ for signal "0"		-30 to +5V
в—Џ for signal "1"		+15 to +30V
Input current
в—Џ for signal "1", typ.		3.7 mA
Input delay (for rated value of input voltage)
for standard inputs
вЂ” parameterizable		Yes
вЂ” at "0" to "1", min.		0.4 ms
вЂ” at "0" to "1", max.		20 ms
вЂ” at "1" to "0", min.		0.4 ms
вЂ” at "1" to "0", max.		20 ms
for counter/technological functions
вЂ” parameterizable		No
Cable length
в—Џ shielded, max.		1 000 m
в—Џ unshielded, max.		500 m
Digital outputs
Number of digital outputs		1
Short-circuit protection		Yes
в—Џ Response threshold, typ.		> 14.8 A
Open-circuit detection		Yes
в—Џ Response threshold, typ.		8 mA
Overload protection		Yes
в—Џ Response threshold, typ.		8.8 A
Limitation of inductive shutdown voltage to		Max. -1.5 V
Switching capacity of the outputs
в—Џ with resistive load, max.		8 A
в—Џ on lamp load, max.		100 W
Load resistance range
в—Џ lower limit		3 в„¦
в—Џ upper limit		2 000 в„¦
Output voltage
в—Џ for signal "1", min.		24 V; L+ (-0.5 V)
Output current
в—Џ for signal "1" rated value		8 A
в—Џ for signal "0" residual current, max.		1.5 mA; PP-switching: max. 1.5 mA; PM-switching: max. 1 mA
Switching frequency
в—Џ with resistive load, max.		10 Hz; Symmetrical
в—Џ with inductive load, max.		0.1 Hz; according to IEC 60947-5-1, DC-13, symmetrical
в—Џ on lamp load, max.		4 Hz; Symmetrical
Total current of the outputs
в—Џ Current per channel, max.		8 A; Note derating data in the manual
в—Џ Current per module, max.		8 A; Note derating data in the manual
Cable length
в—Џ shielded, max.		1 000 m
в—Џ unshielded, max.		500 m
Interrupts/diagnostics/status information
Diagnostics function		Yes, "Alarms/diagnostic messages" section in the manual
Substitute values connectable		No
Alarms
в—Џ Diagnostic alarm		Yes
в—Џ Hardware interrupt		No
Diagnostics indication LED
в—Џ RUN LED		Yes; Green LED
в—Џ ERROR LED		Yes; Red LED
в—Џ Monitoring of the supply voltage (PWR-LED)		Yes; green PWR LED
в—Џ Channel status display		Yes; Green LED
в—Џ for channel diagnostics		Yes; Red LED
в—Џ for module diagnostics		Yes; green/red DIAG LED
Potential separation
Potential separation channels
в—Џ between the channels		No
в—Џ between the channels and backplane bus		Yes
в—Џ between the channels and the power supply of the electronics		No
Permissible potential difference
between different circuits		60 V DC/75 V AC
Isolation
Isolation tested with		707 V DC (type test)
Highest safety class achievable in safety mode
в—Џ SIL acc. to IEC 61508		SIL 3
Ambient conditions
Ambient temperature during operation
в—Џ horizontal installation, min.		0 °C
в—Џ horizontal installation, max.		60 °C
в—Џ vertical installation, min.		0 °C
в—Џ vertical installation, max.		50 °C
Dimensions
Width		20 mm
Height		72 mm
Depth		55 mm
Weights
Weight, approx.		70 g

skener.ru

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
Бесконтактные выключатели Конечные выключатели Оптические датчики Энкодеры

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FS - Установка умягчения

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FK - Установка обезжелезивания