Safety-related electronic modules . Технические данные . Подробное описание, цены на оборудование Siemens. Большой выбор, низкие цены на Safety-related electronic modules

| | | | |

Article number		6ES7138-7FN00-0AB0
		ET200ISP, 8F-DI NAMUR EX, FAILSAFE
Input current
from supply voltage L+, max.		150 mA; int. Powerbus
Encoder supply
Number of outputs		8
Type of output voltage		8 V DC
Power loss
Power loss, typ.		1.4 W
Address area
Occupied address area
в—Џ Inputs		6 byte
в—Џ Outputs		4 byte
Digital inputs
Number of digital inputs		8
Number of NAMUR inputs		8
Input voltage
в—Џ Type of input voltage		DC
Input current
в—Џ for signal "1", typ.		9.5 mA
Input delay (for rated value of input voltage)
for standard inputs
вЂ” at "0" to "1", min.		0.7 ms
вЂ” at "0" to "1", max.		16 ms; Parameterizable
вЂ” at "1" to "0", min.		0.7 ms
вЂ” at "1" to "0", max.		16 ms; Parameterizable
Cable length
в—Џ shielded, max.		500 m
в—Џ unshielded, max.		200 m
Encoder
Number of connectable encoders, max.		8
Connectable encoders
в—Џ NAMUR encoder		Yes
NAMUR encoder
в—Џ Input current for signal "0", max.		1.2 mA
в—Џ Input current for signal "1", min.		2.1 mA
Interrupts/diagnostics/status information
Status indicator		Yes
Diagnostic functions		Yes
Alarms
в—Џ Diagnostic alarm		Yes; Parameterizable
в—Џ Hardware interrupt		No
Diagnostic messages
в—Џ Diagnostic information readable		Yes
в—Џ Wire-break		Yes; NAMUR encoders or single contact with 10 kOhm parallel resistor
в—Џ Short-circuit		Yes; R load < 150 ohms with NAMUR sensor/sensor and NAMUR changeover contact/sensor to DIN 19234
Diagnostics indication LED
в—Џ Group error SF (red)		Yes
Parameter
Diagnostics wire break		channel by channel
Diagnostics short-circuit		channel by channel
Potential separation
Potential separation digital inputs
в—Џ between the channels		No
в—Џ between the channels and backplane bus		Yes
Permissible potential difference
between different circuits		60 V DC/30 V AC
Isolation
Isolation tested with		350 V AC/1 min between the shield and backplane bus connection 350 V AC/1 min between the shield and I/O 2830 V AC/1 min between backplane bus connection and I/O
Standards, approvals, certificates
CE mark		Yes
Highest safety class achievable in safety mode
в—Џ Performance level according to ISO 13849-1		PLe
в—Џ SIL acc. to IEC 61508		SIL 3
Use in hazardous areas
в—Џ Type of protection acc. to EN 50020 (CENELEC)		II 2 G (1) GD Ex ib[ia Ga][ia IIIC Da] IIC T4 GB and I M2 Ex ib[ia Ma] I Mb
в—Џ Type of protection acc. to KEMA		10 ATEX 0056
Dimensions
Width		30 mm
Height		129 mm
Depth		136.5 mm
Weights
Weight, approx.		288 g

Article number		6ES7138-7FD00-0AB0
		ET200ISP, 4F-DO 40MA EX, FAILSAFE
Input current
from load voltage L+ (without load), max.		510 mA; int. Powerbus
Power loss
Power loss, typ.		5.3 W; max.
Digital outputs
Number of digital outputs		4
Short-circuit protection		Yes
в—Џ Response threshold, typ.		Depending on the "short-circuit level" parameter
Controlling a digital input		No
No-load voltage Uao (DC)		17.4 V
Internal resistor Ri		167 в„¦
Load resistance range
в—Џ lower limit		270 в„¦
в—Џ upper limit		18 kв„¦
Trend key points E
в—Џ Voltage Ue (DC)		10.7 V
в—Џ Current Ie		40 mA
Output voltage
в—Џ for signal "1", min.		max. 17.4 V
Output current
в—Џ for signal "0" residual current, max.		10 µA
Parallel switching of two outputs
в—Џ for uprating		Yes
в—Џ for redundant control of a load		No
Switching frequency
в—Џ with resistive load, max.		30 Hz
в—Џ with inductive load, max.		2 Hz
Cable length
в—Џ shielded, max.		500 m
в—Џ unshielded, max.		500 m
Interrupts/diagnostics/status information
Status indicator		Yes
Substitute values connectable		Yes
Alarms
в—Џ Diagnostic alarm		Yes; Parameterizable
Diagnostic messages
в—Џ Diagnostic information readable		Yes
в—Џ Wire-break		Yes
в—Џ Short-circuit		Yes
Diagnostics indication LED
в—Џ Group error SF (red)		Yes
в—Џ Status indicator digital output (green)		Yes
Parameter
Diagnostics wire break		Yes
Diagnostics short-circuit		Yes
Potential separation
Potential separation digital outputs
в—Џ between the channels		No
в—Џ between the channels and backplane bus		Yes
в—Џ Between the channels and load voltage L+		Yes
Permissible potential difference
between different circuits		60 V DC/30 V AC
Standards, approvals, certificates
CE mark		Yes
Highest safety class achievable in safety mode
в—Џ Performance level according to ISO 13849-1		PLe
в—Џ SIL acc. to IEC 61508		SIL 3
Use in hazardous areas
в—Џ Type of protection acc. to EN 50020 (CENELEC)		II 2 G (1) GD Ex ib[ia Ga][ia IIIC Da] IIC T4 GB and I M2 Ex ib[ia Ma] I Mb
в—Џ Type of protection acc. to KEMA		10 ATEX 0057
Dimensions
Width		30 mm
Height		129 mm
Depth		136.5 mm
Weights
Weight, approx.		285 g

Article number		6ES7138-7FA00-0AB0
		ET200ISP, 4F-AI HART EX, FAILSAFE
Input current
from supply voltage L+, max.		490 mA; int. Powerbus
Output voltage
Power supply to the transmitters
в—Џ short-circuit proof		Yes
в—Џ Supply current, max.		25 mA; Plus 4 mA per channel
Power loss
Power loss, max.		5.4 W
Address area
Address space per module
в—Џ Address space per module, max.		16 byte; 12 bytes in the I area / 4 bytes in the O area
Analog inputs
Number of analog inputs		4
Cycle time (all channels) max.		See data in manual
Input ranges
в—Џ Voltage		No
в—Џ Current		Yes
в—Џ Thermocouple		No
в—Џ Resistance thermometer		No
в—Џ Resistance		No
Input ranges (rated values), currents
в—Џ 0 to 20 mA		Yes
в—Џ 4 mA to 20 mA		Yes
Cable length
в—Џ shielded, max.		500 m
Analog value generation for the inputs
Measurement principle		integrating (Sigma-Delta)
Integration and conversion time/resolution per channel
в—Џ Resolution with overrange (bit including sign), max.		16 bit
в—Џ Integration time, parameterizable		Yes
в—Џ Interference voltage suppression for interference frequency f1 in Hz		50 / 60 Hz
Smoothing of measured values
в—Џ parameterizable		Yes; in 4 stages
в—Џ Step: None		Yes; 1 x cycle time
в—Џ Step: low		Yes; 4 x cycle time
в—Џ Step: Medium		Yes; 16 x cycle time
в—Џ Step: High		Yes; 64 x cycle time
Encoder
Connection of signal encoders
в—Џ for current measurement as 2-wire transducer		Yes
вЂ” Burden of 2-wire transmitter, max.		750 в„¦
Errors/accuracies
Linearity error (relative to input range), (+/-)		0.015 %
Temperature error (relative to input range), (+/-)		0.005 %/K
Crosstalk between the inputs, min.		-50 dB
Repeat accuracy in steady state at 25 °C (relative to input range), (+/-)		0.015 %
Operational error limit in overall temperature range
в—Џ Current, relative to input range, (+/-)		0.35 %
Basic error limit (operational limit at 25 °C)
в—Џ Current, relative to input range, (+/-)		0.1 %
Interference voltage suppression for f = n x (f1 +/- 1 %), f1 = interference frequency
в—Џ Series mode interference (peak value of interference < rated value of input range), min.		40 dB
в—Џ Common mode interference, min.		50 dB
Interrupts/diagnostics/status information
Alarms
в—Џ Diagnostic alarm		Yes; Parameterizable
Diagnostic messages
в—Џ Diagnostic information readable		Yes
в—Џ Wire-break		Yes
в—Џ Short-circuit		Yes
Diagnostics indication LED
в—Џ Group error SF (red)		Yes
Potential separation
Potential separation analog inputs
в—Џ between the channels		No
в—Џ between the channels and backplane bus		Yes
в—Џ Between the channels and load voltage L+		Yes; Power bus
Permissible potential difference
between different circuits		60 V DC/30 V AC
Standards, approvals, certificates
CE mark		Yes
Highest safety class achievable in safety mode
в—Џ Performance level according to ISO 13849-1		PLe
в—Џ SIL acc. to IEC 61508		SIL 3
Use in hazardous areas
в—Џ Type of protection acc. to EN 50020 (CENELEC)		II 2 G (1) GD Ex ib[ia Ga][ia IIIC Da] IIC T4 GB and I M2 Ex ib[ia Ma] I Mb
в—Џ Type of protection acc. to KEMA		10 ATEX 0058
Dimensions
Width		30 mm
Height		129 mm
Depth		136.5 mm
Weights
Weight, approx.		299 g

Article number		6ES7138-7AA00-0AA0
		ET200ISP, RESERVE MODULE
Supply voltage
Type of supply voltage		DC
Digital inputs
Number of digital inputs		0
Standards, approvals, certificates
CE mark		Yes
Use in hazardous areas
в—Џ Type of protection acc. to EN 50020 (CENELEC)		II2 G EEx ib IIC T4
в—Џ Test number KEMA		04 ATEX 1251
Dimensions
Width		30 mm
Height		129 mm
Depth		136.5 mm
Weights
Weight, approx.		180 g

skener.ru

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
Бесконтактные выключатели Конечные выключатели Оптические датчики Энкодеры

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FS - Установка умягчения

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FK - Установка обезжелезивания