If pre-assembled signal cables are to be installed in a cable carrier in such a way that the connector would inhibit assembly, pre-assembled cables without assembled connector can also be supplied. In this case, the contacts of the cables are crimped and the connector enclosure is supplied separately. After installing the cables, the customer assembles the connector enclosure.

The 6FX.002-2....-.... signal cables are available with crimped contacts and with the connector enclosure supplied separately (not in the case of DRIVE-CLiQ signal cables or signal cables with exposed core ends).

Signal cables with separately supplied module-end connector enclosure. In this case, the 6th position of the Article No. must be changed from 0 to 1:
6FX.012-2C...-.... (not for signal cables for connection via terminals or 6FX.002-2AH00-...., 6FX.002-2CA12-....).

Signal cables with separately supplied motor-end connector enclosure. In this case, the 6th position of the Article No. must be changed from 0 to 4:
6FX.042-2C...-.... (not for signal cables for connection via terminals or 6FX8002-2BA20-...., 6FX8002-2BA21-....).

Note:

Once the contacts have latched into the insulator, they can no longer be removed.