The hinge switches are used in those areas where the position of swiveling protective devices such as doors or flaps must be monitored. With these switches, the position of the doors and flaps is converted into electric signals. The switches allow shutdown and signaling without delay in the event of a small opening angle through the snap-action contacts with an operating angle of 10°.

Devices are available with enclosure versions to suit the particular ambient conditions. Different control tasks can be performed with the best contact blocks suited for the particular purpose. Dimensions and fixing points of the enclosures are in accordance with EN 50041 or EN 50047 standards.

The devices are suitable for use in any climate.

Standards

IEC/EN 60947-5-1.

The "total insulation" protective measure is guaranteed by the plastic enclosure when using plastic screw-glands.

Safety position switches

For controls according to IEC/EN 60204-1, the devices can be used as a safety position switch. To secure position switches against changes in their position, keyed techniques must be employed on installation.

Safety circuits

Standards IEC 60947-5-1 and EN 60947-5-1 require positive opening of the NC contacts. In other words, for the purposes of personal safety, the assured opening of NC contacts is expressly stipulated for the electrical equipment of machines in all safety circuits and marked in accordance with the IEC standard 60947-5-1 with the symbol (–>).

Category 4 according to EN ISO 13849-1 can be attained with the 3SE5 hinge switches with (–>) if the corresponding fail-safe evaluation units are selected and correctly installed, e.g. the 3SK or 3TK28 safety relays or matching devices from the ASIsafe, SIMATIC or SINUMERIK product ranges.