3TC4817-0LF8

Цена на сайте указана розничная в ЕВРО без учета НДС.
Для уточнения цены и размера предоставляемой скидки - звоните или присылайте заявки

Standards

IEC/EN 60947‑4‑1

The contactors are finger-safe according to IECВ 60529 (exception: series resistor). Terminal covers may have to be fitted onto the connecting bars, depending on the configuration with other devices.

All specifications and technical specifications not mentioned here are identical to those of the standard 3TCВ contactors; see "Contactors for Special Applications" в†’ "3TC Contactors for Switching DC Voltage, 1 and 2-pole".

Ambient temperature

The permissible ambient temperature for operation of the contactors (across the full coil operating range) is -50 to +70В В°C. Uninterrupted duty at temperatures <В -25В В°C and >В +55 В°C reduces the mechanical endurance, the current carrying capacity of the conducting paths and the switching frequency.

At ambient temperatures >В 55 В°C, a clearance of 10 mm is required for side-by-side mounting of size 2 contactors. There is no need to reduce the technical specifications.

Ratings of three-phase motors

The quoted rating (in kW) refers to the output power on the motor shaft (according to the nameplate).

The power rating specifications of the contactors in kW are guide values for 4-pole standard motors at 50В Hz and specified voltage (e.g. 400В VВ AC). The actual starting and rated data of the motor to be switched must be considered when selecting the units.

Series resistor

The DC solenoid systems of the 3TCВ contactors must be modified (to hold-in coil) by means of a series resistor. This series resistor is supplied separately packed with the contactors.

With types 3TC48, the series resistor must be attached onto the right-hand side of the auxiliary switch block by means of the enclosed mounting parts and sets of links provided, while in the case of the 3TC44 it must be mounted and wired between the contactor poles. With types 3TC52 and 3TC56, the series resistor must be attached separately next to the contactors.

Auxiliary contacts

The contactors are equipped with two lateral auxiliary switch blocks each with 1В NO + 1В NC contact. Further auxiliary switch blocks cannot be fitted to the DC-operated contactors.

OneВ NC contact is required for the series resistor function. TwoВ NO contacts and oneВ NC contact are thus freely available.

Reversing contactors

With the 3TC52 and 3TC56 contactors, the series resistor must be connected using an additional K2 reversing contactor (3RT1317‑1F.40). This contactor is automatically included in the scope of supply in the same packaging as the contactor.

Dimensions

Attaching resistors and varistors increases the width of the contactors.