3RK1200-0CG03-0AA2

Цена на сайте указана розничная в ЕВРО без учета НДС.
Для уточнения цены и размера предоставляемой скидки - звоните или присылайте заявки

The counter module is used to send hexadecimally coded count values (LSB=D0, MSB=D3) to a higher-level controller. The count value is increased by one for each valid count pulse at terminal 8. Beginning at 0, the module counts up to 15 and then begins again at 0. The controller adopts the current value and determines the number of pulses between two host invocations through subtraction from the previous value. The total number of count pulses is determined by adding these differences.

For the values sent to be unambiguous, no more than 15 count values are allowed between two host invocations or AS-Interface master invocations at terminal 8. The maximum permissible transmission frequency is calculated from these times:

f_Trmax = 15 / T_max

T_max: maximum possible transmission time from the slave to the host

Another condition for the maximum frequency is the pulse shape required. For the counter to accept a pulse as valid, a Low must have been applied at the input for at least 300 Вµs and a High for at least 1 ms. This results in a controller-independent maximum frequency of

f_Zmax = 1В /В 1.3В ms = 769В Hz (see the following figure).

Maximum frequency for the counter module

If the time criterion stipulated in the graph is violated, the count value is rejected.

The counter is active only for the reset parameter P2 (default). The counter is deleted when P2 is set, and the incoming count pulses are not registered until after P2 is reset again.

Note:

A customized function block is necessary or must be programmed.

Counter module connection options