The Single Motor Modules in booksize compact format feature the following connections and interfaces as standard:
- 2 DC link connections via integrated DC link busbars
- 1 electronics power supply connection via integrated 24 V DC busbars
- 3 DRIVE CLiQ sockets
- 1 motor connection via connector
- 1 safe standstill input (enable pulses)
- 1 safe motor brake controller
- 1 temperature sensor input (KTY84 130 or PTC)
- 2 PE/protective conductor connections
The status of the Motor Modules is indicated via two multi-color LEDs.
The shield of the motor cable is connected via the motor connector.
The signal cable shield can be connected to the Motor Module by means of a shield connection terminal, e.g. type KLBU 3-8 SC from Weidmuller.
The scope of supply of the Motor Modules includes:
- DRIVE CLiQ cable (length depends on module width) to connect Motor Module to adjacent Motor Module,
length 0.11 m for 50 mm wide Motor Modules or
length 0.16 m for 75 mm wide Motor Modules. - 2 blanking plugs for sealing unused DRIVE CLiQ sockets
- Jumper for connecting the 24 V DC busbar to the adjacent Motor Module
- Connector X21
- Connector X11 for motor brake connection
- Connector X1 for motor connection
- 1 set of warning signs in foreign languages
- 1 heat conducting foil