SINAMICS DC MASTER – SIMOREG CCP

The following table lists the SIMOREG CCP units that are suitable for the particular SINAMICS DC MASTER.

This information is based on the rated unit data (taking into consideration the particular limit values) of the components and on the other hand, typical rated data for Siemens DC motors from Catalog DA 12 вЂў 2008.

Note:
For plant and system configurations with reduced rated values (e.g. DC rating, US rating, voltage derating), under certain circumstances, suitable combinations of units can be found that are not listed in the table.

For detailed engineering and when selecting the appropriate CCP, technical support personnel can provide assistance through the local Siemens office. For this purpose, the following plant data must be specified:

• Line supply voltages and power sections
• Required undervoltage range of the power section
• Rated motor armature voltage
• Rated motor current
• Details on the required overcurrent where necessary
  (magnitude, cycle duration)
• Inductance of the load
  (motor, cable plus if required a smoothing reactor)