The Active Line Modules in booksize format feature the following interfaces as standard:

• 1 power connection via screw-type terminals
• 1 connection for the 24 V DC electronic power supply via the 24 V terminal adapter included in the scope of supply
• 1 DC link connection via integrated DC link busbars
• 3 DRIVE?CLiQ sockets
• 2 PE/protective conductor connections

The status of the Active Line Modules is indicated via two multi-color LEDs.

On the 100 mm (3.94 in) wide Active Line Module, the shield for the power supply cable can be connected to the integrated shield connection plate via a terminal element or tube clip, e.g. type KLBU CO 4 by Weidmuller. The terminal element must not be used for strain relief. Shield connection plates are available for the 150 mm (5.91 in), 200 mm (7.87 in) and 300 mm (11.81 in) wide modules.

The signal cable shield can be connected to the Line Module by means of a terminal element, e.g. type KLBU 3-8 SC by Weidmuller.

The scope of supply of the Active Line Modules includes:

• DRIVE?CLiQ cable for connection to the Control Unit for drive control on the immediate left for drive control, length 0.11 m (4.33 in)
• DRIVE?CLiQ cable (length depends on module width) to connect Active Line Module to adjacent Motor Module
  length = width of Active Line Module + 0.11 m (4.33 in)
• 2 blanking plugs for closing unused DRIVE?CLiQ sockets
• Jumper for connecting the 24 V DC busbar to the adjacent Motor Module
• 24 V terminal adapter (X24)
• Connector X21 for digital inputs
• Slide-in fan unit for Active Line Modules 80 kW and 120 kW (the voltage is provided by the Active Line Module)
• 1 set of warning signs in 30 languages
• 1 heat conducting foil (only on Active Line Modules with cold plate cooling)