Roof panel for cable entry in place of a standard closed roof panel
A rectangular cutout (with an angled panel fold along the rear edge) enables cables to be routed into the cubicle. With the aid of a similarly angled slide plate, the remaining gap can be closed down to the maximum cable diameter.
This optional roof panel (without routed cables) provides protection to IP40. If a higher degree of protection is required, it is recommended to incorporate a foam rubber profile or else to foam out the remaining gap.
Foam rubber profile
The foam rubber profile serves as a seal for cubicle cable entry cut-outs. It is provided with adhesive tape on one side.
Roof panel to accommodate busbars in place of a standard closed roof panel
Where it is necessary to mount busbars on the top of system cubicle frame, e.g. for space reasons, this roof panel version serves as an ideal cover.
The cubicle height is increased by 200 mm.
The clear passage provided for the busbars is:
- Height = 170 mm
- Depth = Cubicle depth minus 70 mm.
The panel is perforated in the area of the busbars to permit heat dissipation. The degree of protection provided is IP20.
Side cover panel for busbar roofs
This cover panel serves to prevent impermissible or accidental contact with the busbars. The same cover panel must be fitted on both sides of the roof.
Other versions on request.