PM240‑2 Power Modules in blocksize format communicate via the PM-IF interface with

• the CU310‑2 Control Unit
• the SIMOTION D410-2 Control Unit
• CUA31 or CUA32 Control Unit Adapter

Connection diagram for PM240‑2 Power Modules, frame sizes FSA to FSC, with or without integrated line filter

Connection diagram for PM240‑2 Power Modules, frame sizes FSD to FSF, with or without integrated line filter

With a CUA31/CUA32 Control Unit Adapter snapped on, the PM240‑2 Power Module communicates via a DRIVE‑CLiQ connection with

• a CU320‑2 Control Unit
• an NCU 7.x of SINUMERIK
• SIMOTION D4x5-2 Control Unit

Power and DC link components that are optionally available depending on the Power Module used

The following line-side power components, DC link components and load-side power components are optionally available in the appropriate frames sizes for the Power Modules:

U = Base component

S = Lateral mounting

I = Integrated

– = Not possible

¹⁾ Lateral mounting is the only possible option for push-through variants.

²⁾ PM240‑2 200 V versions, frame sizes FSD to FSF are only available without integrated line filter.

General design information

Inverter comprising a Power Module (PM), a Control Unit (CU), and base components (side view)

• If at all possible, the line filter should be mounted directly below the inverter ¹⁾.
• With lateral mounting, the line-side components have to be mounted on the left side of the inverter, and the load-side
  components on the right side.
• Braking resistors have to be mounted directly on the control cabinet wall due to heating issues.

Recommended installation combinations of the inverter and optional power and DC link components