The Active Line Modules in booksize format feature the following connections and interfaces as standard:

• 1 power connection via screw-type terminals
• 1 connection for the 24 V DC electronics power supply via the 24 V terminal adapter included in the scope of supply
• 1 DC link connection via integrated DC link busbars
• 3 DRIVE?CLiQ sockets
• 2 PE (protective earth) connections
• 1 temperature sensor input for KTY84?130, Pt1000 or PTC (Pt1000 can be used from firmware V4.7 HF17)

The status of the Active Line Modules is indicated via two multi-color LEDs.

For the Active Line Module with a width of 100 mm (3.94 in), the shield of the power connection cable can be connected to the integrated shield connection plate by means of a shield connection terminal or hose clip, e.g. Weidmuller type KLBU CO 4. The shield connection terminal must not be used as a strain relief mechanism. Shield connection sets are available for the 150 mm (5.91 in), 200 mm (7.87 in) and 300 mm (11.81 in) wide Active Line Modules.

The signal cable shield can be connected to the Active Line Module by means of a shield connection clamp, e.g. Weidmuller type KLBU 3-8 SC.

The scope of supply of the Active Line Modules includes:

• DRIVE-CLiQ cable for connection to the adjacent Control Unit on the left for drive control, length 0.11 m (4.33 in)
• DRIVE?CLiQ cable (length depends on Active Line Module width) for connection to the adjacent Motor Module, length = width of Active Line Module + 0.11 m (4.33 in)
• 2 blanking plugs for sealing unused DRIVE-CLiQ sockets
• Jumper for connecting the 24 V DC busbar to the adjacent Motor Module
• 24 V terminal adapter (X24)
• Connector X21 for digital inputs
• Fan insert for Active Line Modules of 80 kW (100 hp) and 120 kW (150 hp) (the voltage for the fan unit is supplied by the Active Line Module)
• 1 set of warning labels in 30 languages