Safety-related electronics modules . Технические данные . Подробное описание, цены на оборудование Siemens. Большой выбор, низкие цены на Safety-related electronics modules

| | | | |

Safety-related Electronics Modules

Article number		6ES7138-7FN00-0AB0
		ET200ISP, 8F-DI NAMUR EX, FAILSAFE
Input current
from supply voltage L+, max.		150 mA; int. Powerbus
Encoder supply
Number of outputs		8
Type of output voltage		8 V DC
Power loss
Power loss, typ.		1.4 W
Address area
Occupied address area
? Inputs		6 byte
? Outputs		4 byte
Digital inputs
Number of digital inputs		8
Number of NAMUR inputs		8
Input voltage
? Type of input voltage		DC
Input current
? for signal "1", typ.		9.5 mA
Input delay (for rated value of input voltage)
for standard inputs
— at "0" to "1", min.		0.7 ms
— at "0" to "1", max.		16 ms; Parameterizable
— at "1" to "0", min.		0.7 ms
— at "1" to "0", max.		16 ms; Parameterizable
Cable length
? shielded, max.		500 m
? unshielded, max.		200 m
Encoder
Number of connectable encoders, max.		8
Connectable encoders
? NAMUR encoder		Yes
NAMUR encoder
? Input current for signal "0", max.		1.2 mA
? Input current for signal "1", min.		2.1 mA
Interrupts/diagnostics/status information
Status indicator		Yes
Diagnostic functions		Yes
Alarms
? Diagnostic alarm		Yes; Parameterizable
? Hardware interrupt		No
Diagnostic messages
? Diagnostic information readable		Yes
? Wire-break		Yes; NAMUR encoders or single contact with 10 kOhm parallel resistor
? Short-circuit		Yes; R load < 150 ohms with NAMUR sensor/sensor and NAMUR changeover contact/sensor to DIN 19234
Diagnostics indication LED
? Group error SF (red)		Yes
Parameter
Diagnostics wire break		channel by channel
Diagnostics short-circuit		channel by channel
Potential separation
Potential separation digital inputs
? between the channels		No
? between the channels and backplane bus		Yes
Permissible potential difference
between different circuits		60 V DC/30 V AC
Isolation
Isolation tested with		350 V AC/1 min between the shield and backplane bus connection 350 V AC/1 min between the shield and I/O 2830 V AC/1 min between backplane bus connection and I/O
Standards, approvals, certificates
CE mark		Yes
Highest safety class achievable in safety mode
? Performance level according to ISO 13849-1		PLe
? SIL acc. to IEC 61508		SIL 3
Use in hazardous areas
? Type of protection acc. to EN 50020 (CENELEC)		II 2 G (1) GD Ex ib[ia Ga][ia IIIC Da] IIC T4 GB and I M2 Ex ib[ia Ma] I Mb
? Type of protection acc. to KEMA		10 ATEX 0056
Dimensions
Width		30 mm
Height		129 mm
Depth		136.5 mm
Weights
Weight, approx.		288 g

Article number		6ES7138-7FD00-0AB0
		ET200ISP, 4F-DO 40MA EX, FAILSAFE
Input current
from load voltage L+ (without load), max.		510 mA; int. Powerbus
Power loss
Power loss, typ.		5.3 W; max.
Digital outputs
Number of digital outputs		4
Short-circuit protection		Yes
? Response threshold, typ.		Depending on the "short-circuit level" parameter
Controlling a digital input		No
No-load voltage Uao (DC)		17.4 V
Internal resistor Ri		167 ?
Load resistance range
? lower limit		270 ?
? upper limit		18 k?
Trend key points E
? Voltage Ue (DC)		10.7 V
? Current Ie		40 mA
Output voltage
? for signal "1", min.		max. 17.4 V
Output current
? for signal "0" residual current, max.		10 µA
Parallel switching of two outputs
? for uprating		Yes
? for redundant control of a load		No
Switching frequency
? with resistive load, max.		30 Hz
? with inductive load, max.		2 Hz
Cable length
? shielded, max.		500 m
? unshielded, max.		500 m
Interrupts/diagnostics/status information
Status indicator		Yes
Substitute values connectable		Yes
Alarms
? Diagnostic alarm		Yes; Parameterizable
Diagnostic messages
? Diagnostic information readable		Yes
? Wire-break		Yes
? Short-circuit		Yes
Diagnostics indication LED
? Group error SF (red)		Yes
? Status indicator digital output (green)		Yes
Parameter
Diagnostics wire break		Yes
Diagnostics short-circuit		Yes
Potential separation
Potential separation digital outputs
? between the channels		No
? between the channels and backplane bus		Yes
? Between the channels and load voltage L+		Yes
Permissible potential difference
between different circuits		60 V DC/30 V AC
Standards, approvals, certificates
CE mark		Yes
Highest safety class achievable in safety mode
? Performance level according to ISO 13849-1		PLe
? SIL acc. to IEC 61508		SIL 3
Use in hazardous areas
? Type of protection acc. to EN 50020 (CENELEC)		II 2 G (1) GD Ex ib[ia Ga][ia IIIC Da] IIC T4 GB and I M2 Ex ib[ia Ma] I Mb
? Type of protection acc. to KEMA		10 ATEX 0057
Dimensions
Width		30 mm
Height		129 mm
Depth		136.5 mm
Weights
Weight, approx.		285 g

Article number		6ES7138-7FA00-0AB0
		ET200ISP, 4F-AI HART EX, FAILSAFE
Input current
from supply voltage L+, max.		490 mA; int. Powerbus
Output voltage
Power supply to the transmitters
? short-circuit proof		Yes
? Supply current, max.		25 mA; Plus 4 mA per channel
Power loss
Power loss, max.		5.4 W
Address area
Address space per module
? Address space per module, max.		16 byte; 12 bytes in the I area / 4 bytes in the O area
Analog inputs
Number of analog inputs		4
Cycle time (all channels) max.		See data in manual
Input ranges
? Voltage		No
? Current		Yes
? Thermocouple		No
? Resistance thermometer		No
? Resistance		No
Input ranges (rated values), currents
? 0 to 20 mA		Yes
? 4 mA to 20 mA		Yes
Cable length
? shielded, max.		500 m
Analog value generation for the inputs
Measurement principle		integrating (Sigma-Delta)
Integration and conversion time/resolution per channel
? Resolution with overrange (bit including sign), max.		16 bit
? Integration time, parameterizable		Yes
? Interference voltage suppression for interference frequency f1 in Hz		50 / 60 Hz
Smoothing of measured values
? parameterizable		Yes; in 4 stages
? Step: None		Yes; 1 x cycle time
? Step: low		Yes; 4 x cycle time
? Step: Medium		Yes; 16 x cycle time
? Step: High		Yes; 64 x cycle time
Encoder
Connection of signal encoders
? for current measurement as 2-wire transducer		Yes
— Burden of 2-wire transmitter, max.		750 ?
Errors/accuracies
Linearity error (relative to input range), (+/-)		0.015 %
Temperature error (relative to input range), (+/-)		0.005 %/K
Crosstalk between the inputs, min.		-50 dB
Repeat accuracy in steady state at 25 °C (relative to input range), (+/-)		0.015 %
Operational error limit in overall temperature range
? Current, relative to input range, (+/-)		0.35 %
Basic error limit (operational limit at 25 °C)
? Current, relative to input range, (+/-)		0.1 %
Interference voltage suppression for f = n x (f1 +/- 1 %), f1 = interference frequency
? Series mode interference (peak value of interference < rated value of input range), min.		40 dB
? Common mode interference, min.		50 dB
Interrupts/diagnostics/status information
Alarms
? Diagnostic alarm		Yes; Parameterizable
Diagnostic messages
? Diagnostic information readable		Yes
? Wire-break		Yes
? Short-circuit		Yes
Diagnostics indication LED
? Group error SF (red)		Yes
Potential separation
Potential separation analog inputs
? between the channels		No
? between the channels and backplane bus		Yes
? Between the channels and load voltage L+		Yes; Power bus
Permissible potential difference
between different circuits		60 V DC/30 V AC
Standards, approvals, certificates
CE mark		Yes
Highest safety class achievable in safety mode
? Performance level according to ISO 13849-1		PLe
? SIL acc. to IEC 61508		SIL 3
Use in hazardous areas
? Type of protection acc. to EN 50020 (CENELEC)		II 2 G (1) GD Ex ib[ia Ga][ia IIIC Da] IIC T4 GB and I M2 Ex ib[ia Ma] I Mb
? Type of protection acc. to KEMA		10 ATEX 0058
Dimensions
Width		30 mm
Height		129 mm
Depth		136.5 mm
Weights
Weight, approx.		299 g

Article number		6ES7138-7AA00-0AA0
		ET200ISP, RESERVE MODULE
Digital inputs
Number of digital inputs		0
Standards, approvals, certificates
CE mark		Yes
Use in hazardous areas
? Type of protection acc. to EN 50020 (CENELEC)		II2 G EEx ib IIC T4
? Test number KEMA		04 ATEX 1251
Dimensions
Width		30 mm
Height		129 mm
Depth		136.5 mm
Weights
Weight, approx.		180 g

skener.ru

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
Бесконтактные выключатели Конечные выключатели Оптические датчики Энкодеры

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FS - Установка умягчения

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FK - Установка обезжелезивания