SIPLUS fail-safe customized modules . Технические данные . Подробное описание, цены на оборудование Siemens. Большой выбор, низкие цены на SIPLUS fail-safe customized modules

| | | | | |

SIPLUS fail-safe customized modules

Article number		6AG1136-6PA00-2BC0
		SIPLUS ET 200SP F-PM-E 24VDC/8A PPM
General information
Product type designation		F-PM-E PPM 24VDC
Product function
? I&M data		Yes; I&M0 to I&M3
Engineering with
? STEP 7 TIA Portal configurable/integrated as of version		V12
? STEP 7 configurable/integrated as of version		V5.5 SP3 / -
? PROFIBUS as of GSD version/GSD revision		V2.3
? PROFINET as of GSD version/GSD revision		V2.31
Supply voltage
Type of supply voltage		24 V DC
Rated value (DC)		24 V
Reverse polarity protection		Yes
Output voltage
Type of output voltage		DC
Encoder supply
Number of outputs		2
Short-circuit protection		Yes; Electronic (response threshold 0.7 A to 2.1 A)
Output current
? up to 60 °C, max.		0.3 A
24 V encoder supply
? 24 V		Yes; min. L+ (-1.5 V)
? Short-circuit protection		Yes
? Output current, max.		600 mA; Total current of all encoders
Digital inputs
Number of digital inputs		2
Source/sink input		Yes; P-reading
Input characteristic curve in accordance with IEC 61131, type 1		Yes
Input voltage
? Type of input voltage		DC
? Rated value (DC)		24 V
? for signal "0"		-30 to +5V
? for signal "1"		+15 to +30V
Input current
? for signal "1", typ.		3.7 mA
Input delay (for rated value of input voltage)
for standard inputs
— parameterizable		Yes
for counter/technological functions
— parameterizable		No
Cable length
? shielded, max.		1 000 m
? unshielded, max.		500 m
Digital outputs
Number of digital outputs		1
Digital outputs, parameterizable		Yes
Short-circuit protection		Yes
Open-circuit detection		Yes
Overload protection		Yes
Limitation of inductive shutdown voltage to		max. 1.5 V
Switching capacity of the outputs
? with resistive load, max.		8 A
? on lamp load, max.		100 W
Load resistance range
? lower limit		3 ?
? upper limit		2 000 ?
Output voltage
? for signal "1", min.		24 V; L+ (-0.5 V)
Output current
? for signal "1" rated value		8 A
? for signal "0" residual current, max.		1.5 mA; PP-switching: max. 1.5 mA; PM-switching: max. 1 mA
Switching frequency
? with resistive load, max.		10 Hz; Symmetrical
? with inductive load, max.		0.1 Hz; according to IEC 60947-5-1, DC-13, symmetrical
? on lamp load, max.		4 Hz; Symmetrical
Total current of the outputs
? Current per channel, max.		8 A; Note derating data in the manual
? Current per module, max.		8 A; Note derating data in the manual
Cable length
? shielded, max.		1 000 m
? unshielded, max.		500 m
Interrupts/diagnostics/status information
Diagnostics function		Yes, "Alarms/diagnostic messages" section in the manual
Substitute values connectable		No
Alarms
? Diagnostic alarm		Yes
? Hardware interrupt		No
Diagnostics indication LED
? RUN LED		Yes; Green LED
? ERROR LED		Yes; Red LED
? Monitoring of the supply voltage (PWR-LED)		Yes; green PWR LED
? Channel status display		Yes; Green LED
? for channel diagnostics		Yes; Red LED
? for module diagnostics		Yes; green/red DIAG LED
Potential separation
Potential separation channels
? between the channels and backplane bus		Yes
Isolation
Isolation tested with		707 V DC (type test)
Standards, approvals, certificates
Suitable for safety functions		Yes
Highest safety class achievable in safety mode
? Performance level according to ISO 13849-1		PLe
? SIL acc. to IEC 61508		SIL 3
Probability of failure (for service life of 20 years and repair time of 100 hours)
— Low demand mode: PFDavg in accordance with SIL3		< 2.00E-05 1/h
— High demand/continuous mode: PFH in accordance with SIL3		< 1.00E-09 1/h
Ambient conditions
Ambient temperature during operation
? horizontal installation, min.		-25 °C
? horizontal installation, max.		60 °C
? vertical installation, min.		-25 °C
? vertical installation, max.		50 °C
Extended ambient conditions
? relative to ambient temperature-atmospheric pressure-installation altitude		Tmin ... Tmax at 1080 hPa ... 795 hPa (-1000 m ... +2000 m)
Relative humidity
— With condensation, tested in accordance with IEC 60068-2-38, max.		100 %; RH incl. condensation/frost (no commissioning under condensation conditions)
Resistance
— against biologically active substances / conformity with EN 60721-3-3		Yes; Class 3B2 mold, fungus and dry rot spores (with the exception of fauna). The supplied connector covers must remain on the unused interfaces during operation!
— against chemically active substances / conformity with EN 60721-3-3		Yes; Class 3C4 (RH < 75%) incl. salt spray according to EN 60068-2-52 (degree of severity 3). The supplied connector covers must remain on the unused interfaces during operation!
— against mechanically active substances / conformity with EN 60721-3-3		Yes; Class 3S4 incl. sand, dust. The supplied connector covers must remain on the unused interfaces during operation!
Dimensions
Width		20 mm
Height		72 mm
Depth		55 mm
Weights
Weight, approx.		70 g

skener.ru

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
Бесконтактные выключатели Конечные выключатели Оптические датчики Энкодеры

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FS - Установка умягчения

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FK - Установка обезжелезивания