SIPLUS S7-300 SM 326 - Safety Integrated . Технические данные . Подробное описание, цены на оборудование Siemens. Большой выбор, низкие цены на SIPLUS S7-300 SM 326

| | | | | | |

SIPLUS SM 326 F digital input module - Safety Integrated

Article number	6AG1326-1BK02-2AB0	6AG1326-1BK02-2AY0	6AG1326-1RF01-4AB0
	SIPLUS S7-300 SM326F DI24	SIPLUS S7-300 SM326F DI24	SIPLUS S7-300 SM326F DI8 NAMUR
General information
Product type designation			F-DI 8x24VDC Namur
Supply voltage
Rated value (DC)	24 V	24 V
Input current
from load voltage L+ (without load), max.	450 mA	450 mA	160 mA
from backplane bus 5 V DC, max.	100 mA	100 mA	90 mA
Encoder supply
Number of outputs	4; Isolated	4; Isolated	8
Type of output voltage			8.2 V DC
Output current
? Rated value	400 mA	400 mA
Power loss
Power loss, typ.	10 W	10 W	4.5 W
Digital inputs
Number of digital inputs	24	24	8
Number of simultaneously controllable inputs
all mounting positions
— up to 40 °C, max.	24	24	8
— up to 60 °C, max.	24; (at 24 V) or 18 (at 28.8 V)	24; (at 24 V) or 18 (at 28.8 V)	8
Input voltage
? Type of input voltage	DC		DC
? Rated value (DC)	24 V	24 V
? for signal "0"	-30 to +5V	-28.8 ... +5V
? for signal "1"	+11 to +30V	+11 to +28.8V
Input current
? for signal "0", max. (permissible quiescent current)	2 mA	2 mA	0.35 to 1.2 mA
? for signal "1", typ.	10 mA	10 mA	2.1 to 7 mA
Input delay (for rated value of input voltage)
for standard inputs
— at "0" to "1", max.	3.4 ms	3.4 ms
— at "1" to "0", max.	3.4 ms	3.4 ms
for NAMUR inputs
— at "0" to "1", max.			1.2 to 3 ms
— at "1" to "0", max.			1.2 to 3 ms
Cable length
? shielded, max.	200 m	200 m	200 m
? unshielded, max.	100 m	100 m	100 m
Encoder
Connectable encoders
? 2-wire sensor	Yes; if short-circuit test is deactivated	Yes; if short-circuit test is deactivated
— permissible quiescent current (2-wire sensor), max.	2 mA	2 mA
Interrupts/diagnostics/status information
Alarms
? Diagnostic alarm	Yes	Yes	Yes; Parameterizable
Diagnostic messages
? Diagnostic information readable	Yes	Yes
Ex(i) characteristics
Module for Ex(i) protection			Yes
Maximum values of input circuits (per channel)
? Co (permissible external capacity), max.			3 µF
? Io (short-circuit current), max.			13.9 mA
? Lo (permissible external inductivity), max.			80 mH
? Po (power of load), max.			33.1 mW
? Uo (output no-load voltage), max.			10 V
? Um (fault voltage), max.			60 V DC/30 V AC
? Ta (permissible ambient temperature), max.	60 °C	60 °C; = Tmax; the rated temperature range of -25 ... +55 °C (T1) applies for the use on railway vehicles according to EN50155	60 °C
Potential separation
Potential separation digital inputs
? between the channels	Yes	Yes	Yes
? between the channels, in groups of	12	12
? between the channels and backplane bus	Yes	Yes	Yes
? between the channels and the power supply of the electronics			Yes
Isolation
Isolation tested with	500 V DC/350 V AC	500V AC for 1 min (internal voltage limiting to ±120V)
Standards, approvals, certificates
CE mark	Yes	Yes	Yes
UL approval	Yes; File E239877	Yes; File E239877
FM approval	Yes; CofC 3028431	Yes; CofC 3028431
RCM (formerly C-TICK)	Yes
KC approval	Yes
EAC (formerly Gost-R)	Yes
Railway application
? EN 50155		Yes; T1 Category 1 Class A/B horizontal mounting position
Highest safety class achievable in safety mode
? acc. to DIN VDE 0801	AK 6	AK 6
? acc. to EN 954	Cat. 4	Cat. 4	Cat. 4
? SIL acc. to IEC 61508	SIL 3	SIL 3	SIL 2 (single-channel), SIL 3 (two-channel)
Ambient conditions
Ambient temperature during operation
? min.	-25 °C; = Tmin	-25 °C; = Tmin	0 °C; = Tmin
? max.	60 °C; = Tmax; *+70 °C where forced convection with a minimum air velocity of 0.7 m/s through the modules and rated voltage of 24 V ±5 % are ensured. If in the course of maintenance or automatic diagnosis it is determined that the admissible specified parameters have been exceeded, the modules should be subjected to a proof test (function check) by the manufacturer.	60 °C; = Tmax; the rated temperature range of -25 ... +55 °C (T1) applies for the use on railway vehicles according to EN50155	60 °C; = Tmax
Extended ambient conditions
? relative to ambient temperature-atmospheric pressure-installation altitude	Tmin ... Tmax at 1080 hPa ... 795 hPa (-1000 m ... +2000 m)	Tmin ... Tmax at 1080 hPa ... 795 hPa (-1000 m ... +2000 m)	Tmin ... Tmax at 1080 hPa ... 795 hPa (-1000 m ... +2000 m)
Relative humidity
— With condensation, tested in accordance with IEC 60068-2-38, max.	100 %; RH incl. condensation/frost (no commissioning under condensation conditions)		100 %; RH incl. condensation/frost (no commissioning under condensation conditions)
Resistance
— against biologically active substances / conformity with EN 60721-3-3	Yes; Class 3B2 mold, fungus and dry rot spores (with the exception of fauna). The supplied connector covers must remain on the unused interfaces during operation!		Yes; Class 3B2 mold, fungus and dry rot spores (with the exception of fauna). The supplied connector covers must remain on the unused interfaces during operation!
— against chemically active substances / conformity with EN 60721-3-3	Yes; Class 3C4 (RH < 75%) incl. salt spray according to EN 60068-2-52 (degree of severity 3). The supplied connector covers must remain on the unused interfaces during operation!		Yes; Class 3C4 (RH < 75%) incl. salt spray according to EN 60068-2-52 (degree of severity 3). The supplied connector covers must remain on the unused interfaces during operation!
— against mechanically active substances / conformity with EN 60721-3-3	Yes; Class 3S4 incl. sand, dust. The supplied connector covers must remain on the unused interfaces during operation!		Yes; Class 3S4 incl. sand, dust. The supplied connector covers must remain on the unused interfaces during operation!
Connection method
required front connector	40-pin	40-pin	1x 40-pin
Dimensions
Width	80 mm	80 mm	80 mm
Height	125 mm	125 mm	125 mm
Depth	120 mm	120 mm	120 mm
Weights
Weight, approx.	442 g	442 g	482 g

skener.ru

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
Бесконтактные выключатели Конечные выключатели Оптические датчики Энкодеры

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FS - Установка умягчения

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FK - Установка обезжелезивания