Optional accessories

Shield connection kit 1 for CU230P?2 HVAC/DP Control Units

Shield connection kit 1 offers optimum shield connection and strain relief for all signal and communication cables. It includes a matching shield bonding plate and all of the necessary connecting and retaining elements for mounting.

Shield connection kit 3 for CU230P?2 PN, CU240E?2 PN and CU240E?2 PN?F Control Units

Shield connection kit 3 offers optimum shield connection and strain relief for all signal and communication cables. It includes a matching shield bonding plate and all of the necessary connecting and retaining elements for mounting.

SINAMICS memory card (SD card)

The parameter settings for an inverter can be stored on the SINAMICS SD memory card. The SINAMICS SD card can be used to pre-parameterize inverters and to clone complete inverter data sets. When service is required, e.g. after the inverter has been replaced and the data have been downloaded from the memory card the drive system is immediately ready for use again. The associated slot is located on the top of the Control Unit.

PC inverter connection kit 2

For controlling and commissioning the inverter directly from a PC, if the STARTER commissioning tool has been installed on the PC.

Installation kit for line-side cable connection, left, for PM330 Power Modules

This installation kit allows supply cables to be brought in from the left-hand side of frame size GX and HX PM330 Power Modules. It is then possible to install the Power Module in the cabinet without any clearance at the top.

Spare parts

Mounting set for PM230 Power Modules

Depending on the frame size, different mounting sets are available for the PM230 Power Modules.

Fan units for PM230 Power Modules

The PM230 Power Module is equipped with an internal and an external fan unit. Both of these can be replaced if necessary.

Replacement fans

The fans for PM240 and PM330 Power Modules are available to order as replacement fans.