Ex-analog input module with HART . Технические данные . Подробное описание, цены на оборудование Siemens. Большой выбор, низкие цены на Ex-analog input module with HART

| | | | | | | |

Ex-analog input module with HART

Article number		6ES7331-7TB10-0AB0
		SIMATIC DP, HART ANALOG INPUT M
Supply voltage
Load voltage L+
? Rated value (DC)		24 V
? Reverse polarity protection		Yes
Input current
from load voltage L+ (without load), max.		180 mA
from backplane bus 5 V DC, max.		100 mA
Output voltage
Power supply to the transmitters
? present		Yes
? Rated value (DC)		15 V; at 22 mA
? short-circuit proof		Yes; approx. 30 mA
? No-load voltage (DC)		29.6 V
Power loss
Power loss, typ.		4.5 W
Analog inputs
Number of analog inputs		2
permissible input current for current input (destruction limit), max.		40 mA
Input ranges
? Current		Yes
Input ranges (rated values), currents
? 0 to 20 mA		Yes
? Input resistance (0 to 20 mA)		50 ?
? 4 mA to 20 mA		Yes
? Input resistance (4 mA to 20 mA)		50 ?
Cable length
? shielded, max.		400 m
Analog value generation for the inputs
Measurement principle		Sigma Delta
Integration and conversion time/resolution per channel
? Resolution with overrange (bit including sign), max.		16 bit; 10 bit to 15 bit + sign
? Integration time, parameterizable		Yes
? Integration time (ms)		2,5 / 16,67 / 20 / 100 ms
? Basic conversion time, including integration time (ms)		2.5 / 16.67 / 20 / 100 (1 channel enabled); 7.5 / 50 / 60 / 300 (2 channels enabled)
? Interference voltage suppression for interference frequency f1 in Hz		10 / 50 / 60 / 400 Hz
Encoder
Connection of signal encoders
? for current measurement as 2-wire transducer		Yes
? for current measurement as 4-wire transducer		Yes
Errors/accuracies
Linearity error (relative to input range), (+/-)		0.01 %
Temperature error (relative to input range), (+/-)		0.01 %/K
Crosstalk between the inputs, min.		130 dB
Repeat accuracy in steady state at 25 °C (relative to input range), (+/-)		0.05 %
Operational error limit in overall temperature range
? Current, relative to input range, (+/-)		0.45 %; From 0/4 to 20 mA
Basic error limit (operational limit at 25 °C)
? Current, relative to input range, (+/-)		0.1 %; From 0/4 to 20 mA
Interference voltage suppression for f = n x (f1 +/- 1 %), f1 = interference frequency
? Series mode interference (peak value of interference < rated value of input range), min.		60 dB
? Common mode interference, min.		130 dB
Interrupts/diagnostics/status information
Diagnostic functions		Yes; Parameterizable
Alarms
? Diagnostic alarm		Yes; Parameterizable
? Limit value alarm		Yes; Parameterizable, channels 0 and 1
Diagnostic messages
? Diagnostic information readable		Yes; possible
? Overrange		Yes; Red LED, signal
? Wire-break in signal transmitter cable		Yes; Red LED, signal
? Short-circuit of the signal encoder cable		Yes; Red LED, signal
? HART communication active		Yes; green LED (H)
Diagnostics indication LED
? Group error SF (red)		Yes
? Channel fault indicator F (red)		Yes
Ex(i) characteristics
Module for Ex(i) protection		Yes
Maximum values of input circuits (per channel)
? Co (permissible external capacity), max.		62 nF
? Io (short-circuit current), max.		96.1 mA
? Lo (permissible external inductivity), max.		3 mH
? Po (power of load), max.		511 mW
? Uo (output no-load voltage), max.		26 V
? Um (fault voltage), max.		250 V; DC
? Ta (permissible ambient temperature), max.		60 °C
Potential separation
Potential separation analog inputs
? between the channels		Yes
? between the channels and backplane bus		Yes
Permissible potential difference
between the inputs (UCM)		60 V DC/30 V AC permitted potential difference (Viso) of signals from hazardous areas
Isolation
tested with
? Channels against backplane bus and load voltage L+		2500 V DC
? Channels among one another		2500 V DC
? Load voltage L+ against backplane bus		500 V DC
Standards, approvals, certificates
CE mark		Yes
UL approval		Yes
FM approval		Yes
RCM (formerly C-TICK)		Yes
KC approval		Yes
EAC (formerly Gost-R)		Yes
Use in hazardous areas
? Type of protection acc. to FM		Class I, Division 2, Group A, B, C, D T4; Class I, Zone 2, Group IIC T4
? Type of protection acc. to KEMA		II 3 G (2) GD Ex nA [ib Gb] [ib IIIC Db] IIC T4 Gc
? Test number KEMA		DEKRA 14 ATEX 0052X
Ambient conditions
Ambient temperature during operation
? min.		0 °C
? max.		60 °C
Connection method
required front connector		1x 20-pin
Dimensions
Width		40 mm
Height		125 mm
Depth		120 mm
Weights
Weight, approx.		260 g

skener.ru

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
Бесконтактные выключатели Конечные выключатели Оптические датчики Энкодеры

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FS - Установка умягчения

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FK - Установка обезжелезивания