|
Order No. |
6ES7 148-4PC00-0HA0 |
|
Technical specifications |
|
|
Product |
SIMATIC ET200pro PS |
|
Power supply, type |
24 V/8 A |
|
Input |
|
|
Input |
3-phase AC |
|
Rated voltage value Vin rated |
400 … 480 V |
|
Note |
320 ... 340 V for max. 1 min |
|
Voltage range |
340 … 550 V |
|
Overvoltage resistance |
Implemented internally with varistors |
|
Mains buffering at Iout rated, min. |
15 ms |
|
Mains buffering |
at Vin = 400 V |
|
Rated line frequency |
|
|
50 Hz |
|
60 Hz |
|
Rated line range |
45 … 66 Hz |
|
Input current at nominal level of the input voltage 400 V nominal value |
0.5 A |
|
Switch-on current limiting (+25 °C), max. |
40 A |
|
I t, max. |
3.5 A ·s |
|
Built-in incoming fuse |
internal, 4 A |
|
Protection in the mains power input (IEC 898) |
Required: Circuit breaker 2.2 ... 3.2 A 3RV2011-1DA10 or 3RV2711-1DD10 (UL 489) |
|
Output |
|
|
Output |
controlled, isolated DC voltage |
|
Rated voltage Vout DC |
24 V |
|
Total tolerance, static ± |
3 % |
|
Static mains compensation, approx. |
0.5 % |
|
Static load balancing, approx. |
0.5 % |
|
Residual ripple peak-peak, max. |
200 mV |
|
Spikes peak-peak, max. (bandwidth: 20 MHz) |
250 mV |
|
Product feature output voltage adjustable |
No |
|
Output voltage setting |
- |
|
Status display |
Green LED for 24 V OK |
|
Signaling |
max. 30 V, 10 mA; Power-Good (High-Pegel 1L+ for Vout in range 21.3 ... 29 V); Overtemperature warning at least 30 s before switch-off (high level 1L+ when the max. internal temperature is exceeded) |
|
On/off behavior |
Overshoot of Vout < 2 % |
|
Startup delay, max. |
1.5 s |
|
Voltage rise, typ. |
40 ms |
|
Rated current value Iout rated |
8 A |
|
Current range |
0 … 8 A |
|
delivered active power typ. |
192 W |
|
short-term overload current at short-circuit during run-up typical |
50 A |
|
Duration of overloading ability for excess current on short-circuiting during the start-up |
100 ms |
|
short-term overload current at short-circuit during operation typical |
50 A |
|
Duration of overloading ability for excess current on short-circuiting during the operational phase |
100 ms |
|
Parallel switching for enhanced performance |
No |
|
Efficiency |
|
|
Efficiency at Vout rated, Iout rated, approx. |
88 % |
|
Power loss at Vout rated, Iout rated, approx. |
25 W |
|
Closed-loop control |
|
|
Dynamic mains compensation (Vin rated ±15 %), max. |
0.5 % |
|
Dynamic load smoothing (Iout: 50/100/50 %), Uout ± typ. |
1 % |
|
Setting time maximum |
2 ms |
|
Protection and monitoring |
|
|
Output overvoltage protection |
< 33 V |
|
Current limitation, typ. |
9.4 A |
|
Characteristic feature of the output short-circuit protected |
Yes |
|
Short-circuit protection |
Electronic shutdown, automatic restart |
|
Enduring short circuit current Effective level maximum |
10 A |
|
Overload/short-circuit indicator |
- |
|
Safety |
|
|
Primary/secondary isolation |
Yes |
|
Potential separation |
Protective extra low output voltage Vout according to EN 60950-1 and EN 50178 |
|
Protection class |
Class I |
|
stray current |
|
|
3.5 mA |
|
0.4 mA |
|
CE mark |
Yes |
|
UL/CSA approval |
No |
|
UL/cUL (CSA) approval |
in preparation UL-Listed (UL 508) |
|
Explosion protection |
- |
|
FM approval |
No |
|
FM approval |
- |
|
CB approval |
Yes |
|
Marine approval |
- |
|
Degree of protection (EN 60529) |
IP67, enclosure type 4 indoor |
|
EMC |
|
|
Emitted interference |
EN 55022 Class A |
|
Supply harmonics limitation |
- |
|
Noise immunity |
EN 61000-6-2 |
|
Operating data |
|
|
Ambient temperature |
|
|
-25 … +55 °C |
|
with natural convection |
|
Ambient temparature |
|
|
-40 … +70 °C |
|
Ambient temparature |
|
|
-40 … +70 °C |
|
Humidity class according to EN 60721 |
Climate class 3K3, no condensation |
|
Mechanics |
|
|
Connection technology |
screw-type terminals |
|
Connections |
|
|
L1, L2, L3, PE: Plug connector HAN Q4/2 |
|
L+, M: 2 x 1.5 mm each (4-pole cable for +/- with open, labeled ends, 4 x 1.5 mm ) |
|
Alarm signals: M12 plug-in connector 5-pin |
|
Width of the housing |
310 mm |
|
Height of the housing |
135 mm |
|
Depth of the housing |
90 mm |
|
Weight, approx. |
2.8 kg |
|
Product feature of the housing housing for side-by-side mounting |
No |
|
Type of mounting wall mounting |
Yes |
|
Type of fixing cap rail mounting |
No |
|
Type of mounting S7-300 rail mounting |
No |
|
Installation |
Can be mounted onto ET200pro mounting rail |
|
Electrical accessories |
Power connector (Input: 3RK1911-2BE30 (6 mm )) (Output: 3RK1911-2BF10 (4 mm )) |