6RX1700-0AS00

Цена на сайте указана розничная в ЕВРО без учета НДС.
Для уточнения цены и размера предоставляемой скидки - звоните или присылайте заявки

The software option “Technology software” in the basic unit is released for use by means of a PIN number.

If the converter is ordered with the appropriate short code, it will be supplied with the software option enabled. The PIN number is supplied with the unit.

If this option is ordered subsequently, the PIN number will be sent to the customer who must enable the option as described in the operating instructions.

Software modules

The following software modules are available:

• Fixed values
• 32 fault message trigger signals
• 8 warning message trigger signals
• 3 connector/binector converters
• 3 binector/connector converters
• 15 adders/subtractors
• 4 sign inverters
• 2 switchable sign inverters
• 12 multipliers
• 6 dividers
• 3 high-resolution multipliers/dividers
• 4 absolute-value generators with filter
• 3 limiters
• 3 limit-value monitors with filter
• 7 limit-value monitors without filter
• 4 mean-value generators
• 4 maximum selections
• 4 minimum selections
• 2 tracking/storage elements
• 2 connector memories
• 10 connector selector switches
• 2 limit-value monitors
• (for dual connectors)
• 2 connector-type converters
• 2 adders/subtractors
• (for dual connectors)
• 3 integrators 3 DT1 elements
• 10 derivative action/ delay elements
• 9 characteristic blocks
• 3 dead zones
• 1 setpoint shift
• 1 simple ramp-function generator
• 1 technology controller
• 10 PI controllers
• 1 velocity/speed/ calculator
• 1 speed/velocity calculator
• 1 calculation of variable torque
• 3 multiplexers
• 1 software counter, 16-bit
• 2 decoders/demultiplexers binary, 1 from 8
• 28 AND elements
• 20 OR elements
• 4 EXCLUSIVE OR elements
• 16 inverters
• 12 NAND elements
• 14 RS flipflops
• 4 D flipflops
• 6 timers (0,000 to 60,000s)
• 4 timers (0,00 to 600,00s)
• 5 binary signal selector switches

Technology controller

The technology controller can be used for higher-level closed-loop controls, such as,tension, position or pressure controllers. The output can be wired as required and can act, for example,as a main setpoint, additional setpoint or current limit.

The technology controller is a PID controller with separate settings for the closed-loop control characteristics. A droop setting is also available.

Connector numbers can be entered freely to select the source for setpoint and actual value. A filter (PT1 element) can be parameterized at the setpoint and actual value inputs.

The technology controller output can be limited by mutually independent, positive and negative values, which can be parameterized or input via freely selectable connectors. The output signal can be weighted multiplicatively (parameterized or via connector signal) after the limiting stage.