3VL4731-2DC36-....

Цена на сайте указана розничная в ЕВРО без учета НДС.
Для уточнения цены и размера предоставляемой скидки - звоните или присылайте заявки

Selection and ordering data

The following table lists recommendations for additional line-side components, such as fuses and circuit breakers. The values in the table take into account the overload capability of the inverter.

Notes for use in compliance with IEC standards:

3NA3 or 3NE1 fuses and 3RV motor starter protectors or 3VL circuit breakers are recommended for European countries.

Notes for use in compliance with UL regulations:

UL-listed fuses Class J or 3NE1 with 600 V AC rated voltage (UL-compliant – corresponds to RU) are required for North America.

Short-Circuit Current Rating SCCR

(Short-Circuit Current Rating) according to UL

Applies to industrial control panel installations acc. to NECВ ArticleВ 409 or ULВ 508A/508C.

• PM230 IP55 versions: 40В kA (FSA to FSC)
• PM230 IP20 versions: 65В kA

Notes regarding installations in Canada:

Overvoltage protection devices in accordance with overvoltage categoryВ III and with the following ratings must be connected on the line side of the inverter:

• Rated voltage 480В V (phase-phase) and 480В V (phase-ground)
• Voltage limit 4 kV (phase-phase) and 6 kV (phase-ground)

All overvoltage protection devices used must comply with Canadian standards for industrial installations.

Additional information about the listed fuses and circuit breakers is available in Catalogs LVВ 10, ICВ 10 and ICВ 10В AO.

¹⁾ Rated power based on the rated output current I_rated. The rated output current I_rated is based on the duty cycle for low overload (LO).

²⁾ ULВ TypeВ 12 only for frame sizes FSA to FSC

*) See Catalog LVВ 10 for Article No. supplements.

В 

¹⁾ Rated power based on the rated output current I_rated. The rated output current I_rated is based on the duty cycle for low overload (LO).

В 

¹⁾ Rated power based on the rated output current I_rated. The rated output current I_rated is based on the duty cycle for low overload (LO).