Power Modules PM240?2 – 0.55 kW to 15 kW, IP20 degree of protection

SINAMICS G120, FSA - FSC, PM230 and PT

Power Modules PM240?2, frame sizes FSA to FSF (with control unit and operator panel)

SINAMICS G120, FSA - FSC, PM230 and PT

Power Modules PM240?2, IP20 degree of protection, push-through version, frame sizes FSA to FSC (with control unit and operator panel)

The new PM240?2 Power Modules are based on a new hardware platform. This permits an increase in power density as well as the application of innovative cooling concepts (push-through technology) with especially high requirements in terms of control cabinet cooling.

Furthermore, the PM240-2 Power Module is also suitable for use in safety-oriented applications. In conjunction with a fail-safe control unit, the drive can be turned into a Safety Integrated Drive. The PM240?2 Power Module frame sizes FSA to FSC are available both with and without an integrated line filter class A of compact design for 200 V and 400 V line voltages. The PM240-2 Power Modules with integrated line filter class A are suitable for connection to TN supply systems. Power Modules without an integrated line filter can be connected to grounded TN/TT systems and non-grounded IT systems.

The cable lengths permitted between converter and motor are limited. Longer cables can be used if output reactors are connected.

Push-through version

The push-through version allows the cooling fins of the Power Module to be pushed through the rear panel of the control cabinet. Push-through versions should be used in applications in which the amount of waste heat generated inside the control cabinet itself must be minimized.

Shield plates and shield connection kits are available for use when wiring control units and power modules to ensure compliance with EMC guidelines.

Note:

SIPLUS extreme products are based on SINAMICS standard products. The contents listed here were taken from the corresponding standard products. SIPLUS extreme-specific information was added.