The following functions are supported on DeviceNet:

• The adapter module corresponds to the DeviceNet specification Volume I, Rel. 2.0 and Volume II, Rel. 2.0.
• All DeviceNet standard baud rates are supported: 125, 250, 500 kBd.
• The baud rate and bus address are set via DIP switches.
• The adapter has three diagnostic LEDs, which provide information about the bus status, the status of the adapter and of the connected IOs.
• Direct data exchange
• The communication services "Polling", "Strobe", "Cyclic", and "Change of State (COS)" are supported.
• Fragmented IO data (cyclic; max. 244 bytes input and output) and explicit (acyclic) data can be used.
• Target/actual comparison of the configuration or detection of configuration changes (Configuration Consistency Value; CCV).
• Heartbeat messages.
• Shutdown messages.
• Up to 63 modules can be plugged in and operated behind an IM.
• It is possible to pack address data within the ET 200S.
• All terminal modules and accessories of the ET 200S can be used.

Please note that safety modules and frequency converters cannot be used. You can find more detailed information on this in SIMATIC Update (article ID: 49851145).

To be able to use the full functionality of the ET 200S IO modules, corresponding software is needed (configuration tool) to change parameters and read diagnostics.

Scope of delivery

• Interface Module
• Bus termination module for ET 200S (6ES7 193-4JA00-0AA0)
• Power module PM-E 24..4 V DC/24..230 V AC (6ES7 138-4CB11-0AB0)
• Terminal module TM-P (6ES7 193-4CD30-0AA0)
• Connector for the connection to DeviceNet.

You can find further information on the adapter module itself on the Molex website.

Parameterization software (DeviceNet Configuration Tool) and PC card

To parameterize the individual ET 200S modules, you need a corresponding software tool, which can be ordered from Molex.

The order number for this tool is: DNSCONFIG (Molex order number)

To use the online functions of the software, you also need a corresponding PC card, which is also available from Molex.

• PCI card for connecting a PC to DeviceNet: SST-DN3-104-1 (Molex order number)
• PCMCIA card for connecting a PC to DeviceNet: 5136-DNP-PCM-ST (Molex order number)