SIPLUS S7-300 Ex analog input module with HART . Технические данные . Подробное описание, цены на оборудование Siemens. Большой выбор, низкие цены на SIPLUS S7-300 Ex analog input module with HART

| | | | | | |

SIPLUS S7-300 Ex analog input module with HART

Article number		6AG1331-7TB00-7AB0
		SIPLUS S7-300 SM331 2AE HART
Supply voltage
Load voltage L+
? Rated value (DC)		24 V
? Reverse polarity protection		Yes
Input current
from load voltage L+ (without load), max.		180 mA
from backplane bus 5 V DC, max.		100 mA
Output voltage
Power supply to the transmitters
? present		Yes
? Rated value (DC)		15 V; at 22 mA
? short-circuit proof		Yes; approx. 30 mA
? No-load voltage (DC)		29.6 V
Power loss
Power loss, typ.		4.5 W
Analog inputs
Number of analog inputs		2
permissible input current for current input (destruction limit), max.		40 mA
Input ranges
? Current		Yes
Input ranges (rated values), currents
? 0 to 20 mA		Yes
? Input resistance (0 to 20 mA)		50 ?
? 4 mA to 20 mA		Yes
? Input resistance (4 mA to 20 mA)		50 ?
Cable length
? shielded, max.		400 m
Analog value generation for the inputs
Measurement principle		Sigma Delta
Integration and conversion time/resolution per channel
? Resolution with overrange (bit including sign), max.		16 bit; 10 bit to 15 bit + sign
? Integration time, parameterizable		Yes
? Integration time (ms)		2,5 / 16,67 / 20 / 100 ms
? Basic conversion time, including integration time (ms)		2.5 / 16.67 / 20 / 100 (1 channel enabled); 7.5 / 50 / 60 / 300 (2 channels enabled)
? Interference voltage suppression for interference frequency f1 in Hz		10 / 50 / 60 / 400 Hz
Encoder
Connection of signal encoders
? for current measurement as 2-wire transducer		Yes
? for current measurement as 4-wire transducer		Yes
Errors/accuracies
Linearity error (relative to input range), (+/-)		0.01 %
Temperature error (relative to input range), (+/-)		0.01 %/K
Crosstalk between the inputs, min.		130 dB
Repeat accuracy in steady state at 25 °C (relative to input range), (+/-)		0.05 %
Operational error limit in overall temperature range
? Current, relative to input range, (+/-)		0.55 %; From 0/4 to 20 mA
Basic error limit (operational limit at 25 °C)
? Current, relative to input range, (+/-)		0.1 %; From 0/4 to 20 mA
Interference voltage suppression for f = n x (f1 +/- 1 %), f1 = interference frequency
? Series mode interference (peak value of interference < rated value of input range), min.		60 dB
? Common mode interference, min.		130 dB
Interrupts/diagnostics/status information
Diagnostic functions		Yes; can be set in parameters, red LED, alarm message
Alarms
? Diagnostic alarm		Yes; Parameterizable
? Limit value alarm		Yes; Parameterizable, channels 0 and 1
Diagnostic messages
? Diagnostic information readable		Yes
? Overrange		Yes; Red LED, signal
? Wire-break in signal transmitter cable		Yes; Red LED, signal
? Short-circuit of the signal encoder cable		Yes; Red LED, signal
? HART communication active		Yes; green LED (H)
Diagnostics indication LED
? Group error SF (red)		Yes
? Channel fault indicator F (red)		Yes
Ex(i) characteristics
Module for Ex(i) protection		Yes
Maximum values of input circuits (per channel)
? Co (permissible external capacity), max.		62 nF
? Io (short-circuit current), max.		96.1 mA
? Lo (permissible external inductivity), max.		3 mH
? Po (power of load), max.		511 mW
? Uo (output no-load voltage), max.		26 V
? Um (fault voltage), max.		250 V; DC
? Ta (permissible ambient temperature), max.		0.6 °C
Potential separation
Potential separation analog inputs
? between the channels		Yes
? between the channels and backplane bus		Yes
Permissible potential difference
between the inputs (UCM)		60 V DC/30 V AC
Isolation
tested with
? Channels against backplane bus and load voltage L+		1500 V AC
? Channels among one another		1500 V AC
? Load voltage L+ against backplane bus		500 V DC
Standards, approvals, certificates
CE mark		Yes
UL approval		Yes; File E239877
FM approval		Yes; CofC 3028431
RCM (formerly C-TICK)		Yes
KC approval		Yes
EAC (formerly Gost-R)		Yes
Use in hazardous areas
? Test number KEMA		KEMA 09 ATEX 0082X
Ambient conditions
Ambient temperature during operation
? min.		-25 °C; = Tmin
? max.		70 °C; = Tmax; 60 °C @ UL/cUL, ATEX and FM use
Ambient temperature during storage/transportation
? min.		-40 °C
? max.		70 °C
Extended ambient conditions
? relative to ambient temperature-atmospheric pressure-installation altitude		Tmin ... Tmax at 1080 hPa ... 795 hPa (-1000 m ... +2000 m) // Tmin ... (Tmax - 10K) at 795 hPa ... 658 hPa (+2000 m ... +3500 m) // Tmin ... (Tmax - 20K) at 658 hPa ... 540 hPa (+3500 m ... +5000 m)
Relative humidity
— With condensation, tested in accordance with IEC 60068-2-38, max.		100 %; RH incl. condensation/frost (no commissioning under condensation conditions)
Resistance
— against biologically active substances / conformity with EN 60721-3-3		Yes; Class 3B2 mold, fungus and dry rot spores (with the exception of fauna). The supplied connector covers must remain on the unused interfaces during operation!
— against chemically active substances / conformity with EN 60721-3-3		Yes; Class 3C4 (RH < 75%) incl. salt spray according to EN 60068-2-52 (degree of severity 3). The supplied connector covers must remain on the unused interfaces during operation!
— against mechanically active substances / conformity with EN 60721-3-3		Yes; Class 3S4 incl. sand, dust. The supplied connector covers must remain on the unused interfaces during operation!
Dimensions
Width		40 mm
Height		125 mm
Depth		120 mm
Weights
Weight, approx.		260 g

skener.ru

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
Бесконтактные выключатели Конечные выключатели Оптические датчики Энкодеры

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FS - Установка умягчения

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 23

Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/kip/kip.php on line 30
SKW-FK - Установка обезжелезивания