Connection of SIMATIC S7-300/SINUMERIK 840D powerline to Industrial Ethernet
Multi-protocol operation with TCP and UDP transport protocol
Adjustable keep-alive function
Two separate interfaces (integrated network separation):
Gigabit interface with one RJ45 port with 10/100/1 000 Mbit/s, full/half-duplex with auto-sensing capability
PROFINET interface with two RJ45 ports with 10/100 Mbit/s full/half-duplex with auto-sensing and auto-crossover functionality via integrated 2-port switch
Communications services via both interfaces:
Open communication (TCP/IP and UDP): Multicast with UDP, including routing between both interfaces
PG/OP communication: Cross-network by means of S7 routing
S7 communication (client, server, multiplexing) including routing between both interfaces
IT communication: HTTP communication supports access to process data via own web pages; e-mail client function, sending of e-mails directly from user program; FTP communication supports program-controlled FTP client communication; access to data blocks through FTP server
Communications services via PROFINET interfaces:
PROFINET IO controller and IO device with real-time properties (RT and IRT)1)
PROFINET CBA
IP address assignment via DHCP, simple PC tool or via program block (e.g. for HMI)
Configuration with STEP 7
Media redundancy (MRP); within an Ethernet network with ring topology, the CP supports the media redundancy procedure MRP (V2.2 or higher).
Access protection by means of configurable IP access list
Module replacement without programming device; all information is stored on the C-PLUG (also file system for IT functions)
Extensive diagnostic functions for all modules in the rack
IT communication
Web function
E-mail function
FTP
Integration into network management systems through the support of SNMP V1 MIB-II
1) possible combinations in parallel operation: - IO controller with IRT and IO device with RT - IO controller with RT and IO device using IRT
Note:
SIPLUS extreme products are based on SIMATIC standard products. The contents listed here were taken from the respective standard products. SIPLUS extreme-specific information was added.
SIPLUS S7-300 CP 343-1 Advanced
Article No.
6AG1343-1GX31-4XE0
BasedOn Article No.
6GK7343-1GX31-0XE0
Ambient temperature range
0 ... +60 °C
Conformal coating
Coating of the printed circuit boards and the electronic components
Technical data
The technical data of the standard product applies, except for the ambient conditions.
Ambient conditions
Relative humidity
100%, condensation/frost permissible. No commissioning if condensation present.
Biologically active substances, compliance with EN 60721-3-3
Class 3B2 mold and fungal spores (excluding fauna). The supplied plug covers must remain in place over the unused interfaces during operation!
Chemically active substances, compliance with EN 60721-3-3
Class 3C4 incl. salt spray in accordance with EN60068-2-52 (degree of severity 3). The supplied plug covers must remain in place over the unused interfaces during operation!
Mechanically active substances, compliance with EN 60721-3-3
Class 3S4 incl. sand, dust. The supplied plug covers must remain in place over the unused interfaces during operation!
Air pressure (depending on the highest positive temperature range specified)
1080 ... 795 hPa (-1 000 ... +2 000 m) see ambient temperature range
795 ... 658 hPa (+2 000 ... +3 500 m) derating 10 K
658 ... 540 hPa (+3 500 ... +5 000 m) derating 20 K
