All-metal 19" enclosure (4 U) for high mechanical resilience (vibration/shock) and high EMC
Prepared for mounting of telescopic rails
Horizontal and vertical installation is possible, can be used as an industrial tower PC by using the appropriate kit.
Lockable front door for authorized access (access protection) to swap media at the front, operating controls (Reset, Power), USB interface, front fan and dust filter
Card retainer for PC modules for safe operation and transport (vibration, shock)
Opening of the enclosure cover with only one screw and replacement of PC components (e.g. PC cards or HDD) with a single tool
Front fan and dust filter can be replaced without tools
Dust protection by means of overpressure ventilation using bearing seated front fan through filter
6 slots for installing drives
Front: 1 x 3.5"; 3 x 5.25" or 1 x 3.5"; 1 x 5.25"; 3 x HDD removable drive bay (low profile)
Internal: 2 x 3.5" (in the optional vibration-damping drive bracket or in the fixed hard disk support)
Graphics on-board, Intel GMA HD integrated in the processor, up to 2048 x 1536 pixels, 60 Hz, 16-bit colors
Interfaces:
2 x LAN 10/100/1000 Mbit/s Ethernet interface (RJ45, team capability)
4 x USB 2.0 at the rear, 2 x USB 2.0 at the front (one of which can be used when door is closed), 1 x internal, e.g. for software dongle
from 1 GB up to 8 GB, DDR3 1066 SDRAM (configured as dual channel for the highest performance from 2 GB upwards)
ECC memory Memory information: In order to use a memory with more than 4 GB, a 64-bit operating system is required. In configurations with at least 4 GB, the visible memory can be reduced to about 3.5 GB or less (with 32-bit operating systems) and in configurations with 8 GB, the visible memory can be reduced to about 7.5 GB or less.
Fieldbus onboard:
PROFIBUS/MPI, CP5611-compatible or PROFINET, 3 x RJ45, CP1616-compatible
Bus module with only 8 spare slots (7 x PCI, 1 x PCI-Express x16)
Graphics expansion:
PCI-Express graphics card x16, (dual head with display port: 2 x VGA or 2 x DVI-D via adapter), 256 MB, up to 2048 x 1536 pixels, 75 Hz, 32-bit colors
Adapter cable (DVI-I to VGA) for the onboard graphics interface (1 x VGA) for connecting an analog monitor
Drives:
SATA/SAS 3.5" hard disks with NCQ technology or SATA 2.5" solid-state drive:
Mounted internally on the permanent hard disk support:
1x 250 GB HDD
1x 50 GB SSD (SLC)
Mounted internally in vibration/shock-absorbing hard-disk support or at the front in a removable drive bay (hot-swap in RAID1/5 configuration):
