The Active Line Modules in booksize format feature the following connections and interfaces as standard:

• 1 power connection via screw-type terminals
• 1 connection for the 24 V DC electronics power supply via the 24 V terminal adapter included in the scope of supply
• 1 DC link connection via integrated DC link busbars
• 3 DRIVE?CLiQ sockets
• 2 PE (protective earth) connections

The status of the Active Line Modules is indicated via two multi-color LEDs.

On the 100 mm (3.94 in) wide Active Line Module, the shield for the power supply cable can be connected to the integrated shield connection plate via a shield connection terminal or tube clip, e.g. Weidmuller type KLBU CO 4. The shield connection terminal must not be used for strain relief. Shield connection plates are available for the 150 mm (5.91 in), 200 mm (7.87 in) and 300 mm (11.81 in) wide modules.

The signal cable shield can be connected to the Line Module by means of a shield connection terminal, e.g. Weidmuller type KLBU 3?8 SC.

The scope of supply of the Active Line Modules includes:

• DRIVE?CLiQ cable for connection to the adjacent Control Unit on the left for drive control, length 0.11 m (4.33 in)
• DRIVE?CLiQ cable (length depends on module width) to connect Active Line Module to adjacent Motor Module, length = width of Active Line Module + 0.11 m (4.33 in)
• 2 blanking plugs for sealing unused DRIVE-CLiQ sockets
• Jumper for connecting the 24 V DC busbar to the adjacent Motor Module
• 24 V terminal adapter (X24)
• Connector X21 for digital inputs
• Fan insert for Active Line Modules of 80 kW (107 HP) and 120 kW (161 HP) (the voltage is supplied by the Active Line Module)
• 1 set of warning signs in 30 languages
• 1 heat conducting foil
  (for Active Line Modules with cold plate cooling only)