Configurable and programmable properties

• I/O setup: Type and scope
• General: Defining the name, plant designation, and location designation
• Start-up Defining the startup characteristics of the CPU and the monitoring time
• Synchronous cycle interrupts: Setting the IO system number, process image partition number, and delay time
• Cycle/clock memory: startup and cycle characteristics: Defining the maximum cycle time and load as well as self-test functions. Setting the clock memory address
• Retentivity: Definition of the number of retentive bit memories, counters, timers and data blocks
• Time-of-day interrupts: Setting the start date, start time, and periodicity of clock memories: Address setting
• Cyclic interrupts: Setting of periodicity
• System diagnostics: Definition of the handling and scope of diagnostic messages
• Protection level: Specifying the access rights to programs and data
• Communication: Reserving the connection resources
• Web: Settings for the Web server of the CPU
• Parameters: Setting the module parameters for the entire ET 200S station
• PROFINET interface: Setting the addresses. Parameterizing the PROFINET properties, the I-Device functionality on PROFINET, the time synchronization using the NTP procedure, the media redundancy, and the KeepAlive function
• Parameterizing Port 1, Port 2 and Port 3

Display and information functions

• Status and error functions; LEDs indicate, for example, hardware, programming, time or I/O errors, as well as operating states such as RUN, STOP, restart, etc.
• Test functions; the PG is used to indicate signal status during program execution, to modify process variables independently of the user program and to output the contents of stack memories
• Information functions; you can use the programming device to obtain information about the storage capacity and operating mode of the CPU as well as the current utilization of the main and load memories, current cycle times and diagnostic buffer contents in plain text

Programming, parameterization

The ET 200S with IM 151-8 PN/DP CPU can be programmed, configured and diagnosed with STEP 7 system-wide from any point in the network.