SIMATIC DP, СОЕДИНИТЕЛЬ ДЛЯ ПОДКЛЮЧЕНИЯ К PROFIBUS, ДО 12 МБИТ/С, ОТВОД КАБЕЛЯ ПОД УГЛОМ 90 ГРАДУСОВ, 15.8 X 54 X 34 MM, С ВСТРОЕННЫМ ТЕРМИНАЛЬНЫМ РЕЗИСТОРОМ, С ФУНКЦИЯМИ РАЗДЕЛЕНИЯ, С ГНЕЗДОМ ДЛЯ ПОДКЛЮЧЕНИЯ ПРОГРАММАТОРА
51.83 ?
SIPLUS CP 443-5 Extended
DP-V1 master connection of the S7-400 to PROFIBUS
For setting up additional PROFIBUS DP lines
Communications services:
PROFIBUS DP
PG/OP communication
S7 communication
S5-compatible communication (SEND/RECEIVE)
Clock synchronization
Easy programming and configuration over PROFIBUS
Cross-network programming device communication through S7 routing
Can be easily integrated into the SIMATIC S7-400 system
Module replacement without PG
SIMATIC H system operation for redundant S7 communication or DP master communication
Data record routing (PROFIBUS DP)
Adding or modifying distributed I/O during operation
Note:
SIPLUS extreme products are based on SIMATIC standard products. The contents listed here were taken from the respective standard products. SIPLUS extreme-specific information was added.
SIPLUS CP 443-5-Extended
Article No.
6AG1 443-5DX05-4XE0
Order No. based on
6GK7 443-5DX05-0XE0
Ambient temperature range
0 ... +60 °C
Conformal coating
Coating of the printed circuit boards and the electronic components
Technical specifications
The technical specifications of the standard product apply, except for the ambient conditions
Ambient conditions
Relative humidity
100%, condensation/frost permitted. No commissioning in bedewed state.
Biologically active substances, compliance with EN 60721-3-3
Class 3B2 mold and fungal spores (excluding fauna). The supplied plug covers must remain in place over the unused interfaces during operation!
Chemically active substances, compliance with EN 60721-3-3
Class 3C4 incl. salt spray in accordance with EN60068-2-52 (degree of severity 3). The supplied plug covers must remain in place over the unused interfaces during operation!
Mechanically active substances, compliance with EN 60721-3-3
Class 3S4 incl. sand, dust. The supplied plug covers must remain in place over the unused interfaces during operation!
Air pressure (depending on the highest positive temperature range specified)
1080 ... 795 hPa (-1000 ... +2000 m) see ambient temperature range
