Connection example for Active Interface Module

The Active Interface Module requires a 24 V DC supply for operation of the integral fan.

The fan rotates after the 24 V DC supply is applied and can, if necessary (service life, noise), be shut off fom the Control Unit over the "Fan off" input. It is only permitted to switch off the fan when the infeed of the drive system is not operating, otherwise the Active Interface Module will overheat.

The thermostatic switch installed in the Active Interface Module is evaluated over the connected Active Line Module.

The power cables between the Active Interface Module and Active Line Module must be shielded if limit values for interference suppression are to be complied with. The cable shield can be routed over the shield connection plate (option) to the Active Interface Module or Active Line Module.

Depending on the position of the Active Interface Module in the drive system, additional DRIVE?CLiQ cables may be required. If it is separately installed next to the left side of the Control Unit and Active Line Module, no additional DRIVE?CLiQ cables are required. If the Active Interface Module is placed between the Control Unit and Active Line Module, the DRIVE?CLiQ cables supplied with the Active Line Modules are suitable for setting up a line topology, i.e. Active Line Module and all Motor Modules in series on one DRIVE?CLiQ line. If the Active Line Module is connected over a separate DRIVE?CLiQ line, the DRIVE?CLiQ cable marked with (1) must be ordered. A DRIVE?CLiQ cable suitable for connection (2) is included in the scope of supply of the Active Line Module.

For DRIVE?CLiQ cables for different configurations, see chapter MOTION?CONNECT connection systems).

Separate Active Interface Module

Active Interface Module integrated in the drive line-up