Чертеж

Заказные данные

¹⁾ For the paint finish, 1FK702 motors must be ordered with 3 or 5 in the 16th data position.

²⁾ For primer, 1FK702 motors must be ordered with 0 or 2 in the 16th data position.

When ordering a motor with options, -Z should be added to the order number.

M03
Version for Zone 2 hazardous areas
according to IEC EN 60079-15

Combustible or explosive gases or vapors occur only rarely or briefly in Zone 2 areas. The type of protection designation is EEx nA II (non sparking).

The special conditions for operating 1FK7 motors in Zone 2 areas, in particular the reduction in permissible operating speeds, are described in detail in Appendix 610.40063.01 to the EC Declaration of Conformity 664.20025.21.

M39
Version for Zone 22 hazardous areas
according to IEC EN 61241-1

Combustible or potentially explosive dust (non-conductive dust) occurs only rarely or briefly in Zone 22 areas. The type of protection designation is Ex 3D T 150 °C.

The special conditions for operating 1FK7 motors in Zone 22 areas are described in detail in Appendix 610.40071.01 to the EC Declaration of Conformity 664.20031.21.

Note regarding M03 and M39 options:

When used in Zone 2 or Zone 22, 1FK7 motors are only designed for encoder connection through connectors. A version with a DRIVE-CLiQ interface on the motor is not possible. Connection to SINAMICS S120 is only possible via SMC (Sensor Module Cabinet-Mounted).

N05
Non-standard shaft extension
(dimensions as for 1FT5 motors)

1FK7 motors are shipped with the following shaft dimensions that are compatible with 1FT5 motors:

• SH 36: 11 ? 23 mm (0.43 ? 0.91 in)
• SH 48: 14 ? 30 mm (0.55 ? 1.18 in)
• SH 63: 19 ? 40 mm (0.75 ? 1.57 in)
• SH 80: 24 ? 50 mm (0.94 ? 1.97 in)
• SH 100:32 ? 58 mm (1.26 ? 2.28 in)

Note:
1FK706 motors with Option N05 do not have a compatible flange with 1FT506 motors.

N16
Version for increased chemical resistance
with protective properties checked
according to DIN EN ISO 4628?1

Suitable for all areas with increased demands on the protective properties of the paint system. These requirements can comprise contact with acids (e.g. phosphoric acid), alkali (e.g. activated chlorine), disinfectant (e.g. hydrogen peroxide and peracetic acid), saltwater among others.

Note:
The PS Premium paint finish has been tested with a broad spectrum of industrial cleaning agents in the pH range of 1.5 – 13. Resistance to the acidic and alkaline cleaning agents and disinfectants in general use was verified in a material resistance test conducted by the company ECOLAB Deutschland GmbH.

Option N16 is only available for the following motor versions:

1FK7…-…..-1C.. AM24DQI encoder

1FK7…-…..-1E.. AM2048S/R encoder

1FK7…-…..-1R.. AM20DQI encoder

1FK7…-…..-1S.. Resolver, mulit-pole (without DRIVE-CLiQ interface)

1FK7…-…..-1T.. Resolver, 2-pole (with DRIVE-CLiQ interface)