Commissioning SINAMICS DCM

Description/learning objective

This training course explains how you adapt the parameter settings of the converter to the application and the DC motor. You expand your theoretical knowledge in the form of exercises carried out on special training equipment. After participating in the course, you know the functions of a converter and the interfaces. You are in a position to safely and quickly commission the unit. Through routine fault diagnostics and troubleshooting, you save time and optimize the availability of your plant or system.

Target group

Commissioning engineers, project engineers, service personnel

Preconditions

Basic knowledge of electrical engineering

Content

• Design and function of the SINAMICS DC MASTER converter:
  • Control module CUD
  • Power section
  • Field circuit
  • Interfaces
  • Circuit diagrams
• Commissioning and parameterizing using the BOP20 and AOP30 operator panels and the STARTER PC program
• Using the memory card: Structure and data backup
• Procedure when commissioning, checking functions
• Optimizing the closed-loop current and speed control, automatic optimization
• Function diagrams: Setpoint channel, inputs and outputs, free function blocks
• Information on Drive Control Chart DCC
• Drive interface to PROFIBUS / PROFINET
• Expanding the system using Terminal Modules and Sensor Modules via DRIVE-CLiQ
• Parallel circuit configuration and peer-to-peer coupling
• Operating states, alarms and fault messages
• Service functions: Trace, measuring functions, diagnostics memory
• Practical exercises using AOP30 and STARTER on training equipment

Note:
This course is subject to export regulations
AL: N, ECCN: EAR99T