Deprecated: Function eregi() is deprecated in /home/h101150-2/siemens71.ru/docs/new/cat.php on line 184
The following components can be connected to the SINAMICS S120 Combi drive system:
- SINUMERIK 828D BASIC T
- SINUMERIK 828D BASIC M
- SINUMERIK 828D
- 3 or 4 spindles/feed motors
- 3 or 4 motor encoders
- 3 or 4 direct encoders via DMC20
- Direct spindle encoder directly via TTL or sin/cos via SMC20
- External fan module
- Up to two additional Motor Modules in booksize compact format via DC link connection and 24 V DC busbars
- Braking Module with braking resistor via DC link connection1)
- Control Supply Module via DC link connection and 24 V DC busbars1)
- One safe motor brake control
- 5 or 6 DRIVE-CLiQ sockets
- 24 V electronics power supply via connector
- 1 safe standstill input for the infeed (enable pulses)
- 1 safe standstill input for the spindle and feeds (enable pulses)
- 1 temperature sensor input for the spindle (KTY84-130 or PTC)
- PE/protective conductor connections
The scope of supply of the SINAMICS S120 Combi Power Modules includes:
- SINAMICS S120 Combi Power Module
- Accessories pack comprising:
- 4 DRIVE-CLiQ dust-proof blanking plugs
- Connector X224 for electronics power supply
- Connector X11 for motor brake control
- Connector X21 enable pulses infeed
- Connector X22 enable pulses drives/temp.
- 5 shield connection terminals for power cables
- Shield connection terminal for signal cable
1) For information about the Braking Module and Control Supply Module, please refer to Catalog NC 61 or the Siemens Industry Mall.