More information

N 141/31

KNX / DALI Gateway Twin

• Communication via KNX EIB with electronic ballasts (ECG) with a DALI interface
• Two (2) DALI output acc. to IEC 60929, each for communication with up to 64 DALI ballasts and at least 10 sensors
• Integrated power supply with input voltage 110...240 V AC, 50...60 Hz or 120...240 V DC for powering the gateway electronics and DALI output
• Maximum DALI output voltage of 19 V, short circuit resistant
• Incorrect voltage detection during commissioning, whether incorrect power line is connected to a DALI output
• LC display for displaying operation mode and error messages
• Pushbutton for switching between bus and direct operating mode
• One pair of push buttons for switching On/Off of all connected DALI ballasts
• One LED per DALI output for status signal of all connected luminaries in direct mode
• Configurable assignment of max. 128 DALI ECG to max. 32 DALI groups, exclusive controlled in groups (switching, dimming, set dimming value) and feedback for group status and lamp failure
• Configurable behaviour for bus failure (stand-alone mode)
• Control (switching, dimming, set dimming value) of all connected luminaries together in broad-cast mode
• Status signal and display of lamp and ECG failure per group and per DALI device
• Possibility to reintegrate defective DALI ECG without software
• One or two level timer
• Integrated scene control for up to 32 scenes
• 16 integrated 2-level-controller for brightness control
• Assignment of DALI ECG to groups and test option for ECG, groups and scenes via ETS during commissioning
• Assignment of DALI sensors and test option of sensors via ETS during commissioning
• Integrated bus coupling unit with only half a standard bus load, bus connection via bus terminal
• Mounting on DIN rail EN 60715-TH35-7.5