The SMC30 Sensor Module Cabinet?Mounted features the following connections and interfaces as standard:

• 1 encoder connection including motor temperature sensing (KTY84?130, Pt1000 or PTC) either via SUB-D connector or via terminals
• 1 DRIVE-CLiQ interface
• 1 connection for the electronics power supply via the 24 V DC supply connector
• 1 PE (protective earth) connection

The status of the SMC30 Sensor Module Cabinet-Mounted is indicated using a multi-color LED.

The SMC30 Sensor Module Cabinet-Mounted can be snapped onto a TH 35 standard mounting rail according to EN 60715 (IEC 60715).

The maximum encoder cable length between SMC30 modules and encoders is 100 m (328 ft). For HTL encoders, this length can be increased to 300 m (984 ft) if the A+/A- and B+/B- signals are evaluated and the power supply cable has a minimum cross-section of 0.5 mm².

The signal cable shield can be connected to the SMC30 Sensor Module Cabinet?Mounted via a shield connection terminal, e.g., Phoenix Contact type SK8 or Weidmuller type KLBU CO 1. The shield connection terminal must not be used as a strain relief mechanism.